One thing, if you plan on auctioning it off, it would be simpler for a non-car guy if it were a 302 rather than a 351. If someone moderately...
Since it was asked, my first impression was "wow". It felt like a different car, the steering was *so* much tighter. Manual steering requires a...
Your right foot must be huge! Seriously, 4mpg? wow... At one time I got 19mpg with a stock 302, 4bbl Holley and dual exhaust, average was about...
351w and 351c are 280z imbalance.
The 250 Bell should be the same, so I've been told, the 200/170 bellhousing is a different beast for certain.
Another thing to keep in mind, if it worked fine before, it might have a piece of trash in the system somewhere, maybe in the hydrualic cylinder.
Those valves are fun. Takes some time to tweak, and sometimes you just can't fix it. On my 4 door, we rebuilt the control valve, worked absolutely...
I can tell ya, on a 289, the air gap is *much* better than the regular Performer intake, assuming its not a stock engine.
It will make the power output stronger, not the block itself, and often make the engine more efficient. The block itself can only handle so much...
Most that dynoed at 120 rwhp were bone stock and probably needed a tune, right after they got the car. One was a lady that joined the forum a year...
See, I said 160, he says 156. :thumbsup:
143hp is the worse case scenario assuming the engine is in tune and doesn't have any mechanical problems to cause lower power. A good guesstimate...
SAE Net from 72 until whenever was measured at the back of the tranny with all accessories installed and running, so a 74 Comet/Mav with AC, power...
I had to play with my timing a bit, the engine and AOD have to be kinda in sync for it to shift right. Get the tranny right, then play with the...
from http://www.txchange.com/aodadj.htm This is how I did mine, but I didn't actually mark the cable. I'd recommend using a black sharpie marker...
85 Mustang was a carb or throttle body, right? I used my kickdown lever for a bit, my donor car had a throttle body that pushed the lever, not...
I had similar problems, it was my alternator bearings. Fixed that, then I could hear the speedo cable... grrr...
Care to elaborate? I haven't run into or read about this yet, and I don't want to run into it after I put it all together. It is just limited to...
My pitman hit my Super Comps on my 302. A couple of turns of the control valve replacement took care of it. Power steering or manual?
Dunno about the rolled pin... As for play, very little, as in almost none. When I wiggle my steering wheel just a tad, you can see the wheels...
Separate names with a comma.
