[ATTACH]
After lower hose R&R, went for a drive with distributor settings of: 10 initial, 9 manifold vac, about 25 mechanical all in by 3K. The difference...
Lol....I just read about that wire "limiter"....but your picture is worth a thousand words and is way easier to comprehend. I got 24-26...
That seems to be the consensus....so I need lighter springs in the mechanical advance? Is it a matter of taking out what is there and swapping...
I finally tracked down my vacuum gauge, and put a tee in my vac adv hose (hooked to manifold vacuum) to run the gauge. Hooked up timing light. My...
Well, I have done a bit of reading, which is my substitute for experience, and what I gather is that idle and cruise fuel mixtures tend to be lean...
I think I am BEGINNING to understand the whole manifold vacuum thing. I currently have initial set at about 16 degrees with the vac advance...
My car came with a dash cap.....I thought it was a real dash. I never seen a cap before and was surprised when I bumped it and it moved!
No time slip yet, but mostly dialed in, and can say that with whatever cam is in there, the power doesnt happen until 4K, but pulls fairly hard up...
It looks like the Comet will be the recipient of all the R&D done in the mav. If it is anything like slot car racing/building, R&D never ends. I...
Welcome from Portland OR. I have had my car and been a member here for about 20 months. It is my first Comet/Ford since a brief ownership of a...
find some good pictures and make sure you got it put back together with stuff in the right place. If you did one side at a time, parts should be...
P&P sale + 93 F150 ministarter = OE boat anchor starter in the scrap heap. :Woot:
I dropped my gas tank, removed the vent, cleaned the tank sealer from the orifice, blew through it, put gasgacinch on both surfaces and...
They are beautiful....and WAAAAAY better than black alone.
The 8088s started out perfect.....but after settling a bit, my tires will rub in situations where you have to turn sharp. I have small bumpers,...
The front of this car looks like it will be quite strong when it is done. Fabbing shock towers is a bit beyond my welding abilities, but I imagine...
I have intermittent flooding that stalls my car and leaves it in a state that it wont start easily. Yesterday I replaced the float valve seats,...
They look good Frank! hey, I'm probably opening a can of worms, but.....if getting your wheels done satisfactorily has been this difficult.....is...
Some? heheheheheheh.
Separate names with a comma.
