I bought a new bushing before transmission installation. When I removed the tail housing to R&R, the original one looked fine....so I measured the...
This is right. From what I have read, 1 inch out from seated is about optimum. Since my front U-joint is bad, I will insert the yoke (minus the...
I pulled out my driveshaft to R&R U-joints and get rid of a vibration. I also pushed my slip yoke all the way in, and it has to slide back 1 3/4...
LOL.....that is not what I was expecting to see, but the color looks good!
Measure from the surface that contacts the end of the crankshaft to the surface the pulley bolts to. If this measurement is the same as your old...
I have an 84 ford pick up that needs gaskets and the whole engine looks like that tube. But guess what? It is a 190K 4.9 mule and the hood stays...
I got a 2 belt crank pulley out of the junk palace (those are getting hard to find) yesterday, soaked it in white vinegar overnight, wire brush...
Nice! Does this trick work for the turn signal plastic end?
I put 90* in the front and straight in the back, as my control arms got moved 1" down and slightly to the rear. This made room for a front 90 and...
The lower radiator hose in the sixties was on the passenger side of the radiator, and the water pump for that set up had the hose connection over...
Oh my. If they gave it a road test, I guess the fact that it moved forward was enough? I hope there is a simple resolution.
I certainly hope that issue leaves....you have jumped through so many hoops to fix it.
Last fall I purchased a very low mile Holley 4160. I went through it to return it to factory specs, do preliminary float adjusments, etc. I...
I watched it one more time. That makes 4 and no more. Comparing the "blistering" 220hp 302 to the 5.0 225hp without consideration of differing...
Huh. Right below the spring compressor the seller has spring perches with grease fittings and bushings made from "synthetic elastomer." Almost...
I used B last summer. First time to compress springs for me. Be careful, and oil the threads! Autozone will let u borrow one for a $50.00...
The guy has a sense of humor even though I disagree with his rant. I would not slam him, but I dont think gas went to $2.25/gallon until the '80s,...
Welcome from Portland, OR.
Emissions, 5 mph bumpers, and no v8 in the Mustang.....1974 was a painful year for automakers. Regulators were increasingly setting the benchmark...
Welcome from Portland, OR. Post some pics of that one family owned car....very nice history. Sounds like one to keep for the next generation.
Separate names with a comma.
