I torqued them twice, I will check them again today...
looks good...
I thought I was doing it for oil seepage...lol
OK here is what I did... I pulled and cleaned the intake and block surfaces, added a skim coat of rtv around the four water ports installed the...
OK got it, thanks...:Handshake
OK if I get the gear off, do I run the drill in forward or reverse ? I'm guessing reverse because dizzy turns counter clockwise...
I guess I can use a cut off wheel on the gear I broke a hunk off hitting it with a hammer...
yes But I can't get the iron gear off, I took out the pin but the gear is frozen on...
Because I'm new at this, when it's time for my first start up. Can I just prime my new roller 5.0 by cranking it with the plugs out and coil wire...
I will be putting my vinyl top back on when I finally get it professionally painted.. Mine will be stored under roof when not out driving it.. I...
I've never installed a intake before, I used the gasket that came in the box of gaskets the engine builder supplied it seamed to have a better...
I got the engine bay painted, going to put the clutch and trans on next... One step closer to the install...
Good info,thanks .. the gaskets I put on lined up pretty good.. I'm going to pull the intake (weand stelth) and make sure the cross over is...
http://www.summitracing.com/parts/mrg-5834/applications/ I'm thinking this is the gasket I need (not so much the brand,but style)
Is the smog cross overs the the funny shaped ports in the middle of the head ? I have a extra little gasket that fits inside the intake gasket...
I'm starting to second guess if I have the right intake gaskets for my 302. The heads are e7 and I'm using a carb. The set I have are felpro #1250...
Just to make you laugh, on my 1st maverick I decided to rebuild my carb. It's just a one barrel how hard could it be. Well on that carb I could...
Looks good....
I like the Mav and those are cool trucks....
:Welcome:from Ocala,Florida......
Separate names with a comma.
