jason, I'm pretty sure the axles will swap with no problems as long as they are both 8 inch rears
If you are still unsure, while the car is up in the air have a friend try to hold one rear tire "in place" while you turn the other. If it isn't...
jack the rear of the car up and spin one wheel. If the wheel on the other side spins in the opposite direction it is an open rear. If it spins...
Will, you are correct. I suggest you use an older timing cover. I used a 74 timing cover so I can still check the oil level. If you run an...
Will, are you talking about the C4 column shift linkage? If so, the above post tells it all. The 87 block does not have the threaded "hole" for...
Tom, if you have power steering it is much more difficult. You may want to drop the slave cylinder if you have PS
I assume you want to run the EFI, if not, no probblems
intakes Charlie, the crown vic intake has a 50mm throttle body and throttle body opening whereas the mustang has a 58 tb and opening. Big...
K. we used the mustang motor. The truck intakes are very different, more like the holley systemax intakes. The non GT intakes are inline. We...
K. Merring, question??? K. Merring, what about turning the intake around doesn't work? The reason I ask is because we did it on a 69 EFI...
It is possible to turn the upper intake around which may allow the booster to clear. In any case you will need different braces. Turning it...
trans mount K. Merring, did you bolt up the AOD using that extension plate? I was wondering if that would work. It doesn't interfere with any...
thanks bossmav What if I used the tubular motor mounts and the stock manifolds. Would any cutting be necessary. I have all of the parts to...
mavaholic what is your break-in procedure? Stock 5.0 rollers have a rev limit of 5800 rpm built into the computer. In your post you indicated...
RR, I realize that the 71 stang would be bigger than the mav but would manifolds from a 70 351C stang be any different than a 71 351C stang? I...
RR, I assume the 71 351C manifolds are different due to a wider engine bay in that year?
Will, didn't realize it was you. You will need wiring diagrams for the same year mustang that you remove the harness from. If you go with a 91 I...
saw your post on the corral net. going to EFI?
RR........ they made a 2bbl cleveland 1970 mustang?
A while back we were discussing a 351C in a maverick. I found the old thread, but we never addressed a boss 302 in the maverick. Does anyone...
Separate names with a comma.
