mavaholic, that makes more sense!
275s on rear Courier, can you post a pic of the 275s? Also, mavaholic. You say that the 255s fit on the narrowed rear but not the stock one....
picture of EFI attached a picture of EFI in my mav. Only able to get one pic and in my defense, it is in the last stages of prep before paint,...
where did you get the intake tube? Also, where do the fuel lines come in?
Are the rings and bearings worn? I believe the 1991 has forged pistons so try to retain the factory pistons. Does it need to be freshened? Just...
But an EFI powered 302 boss carries a lot of shock power!
TL, you could very well be correct. It has been several years since I performed the conversion. I thought I remembered the tie rod "sitting...
something to keep in mind As I recall, there was a change in brakes in 73 or 74. I discovered this issue when I switched to disc brakes. The...
The Mustang Depot carries clevor stroker kits and manifold adaptor kits. I believe their manifold kit starts at 169.00. Much cheaper than price...
I agree with Bluegrass. Don't mix and match!
Try this link: http://www.jason.fletcher.net/tech/cleveland2v/cleveland2v.htmyou can use the cleveland heads with standard 302 pistons if you stay...
Can't argue with free! Are you planning on installing the EFI? If so, do yourself a favor and don't do it twice!! go with the HO setup to begin...
75cometgt, pay attention to what bluegrass has to say, good info on the problems with using lincoln motors. You indicated that the intake inlet...
try this link http://www.jason.fletcher.net/tech/cleveland2v/cleveland2v.htm
be careful, many cams are ground with 4 degrees of advance built in! Degree it in!
stock converter will be fine. Your duration is well within limits and the lobe separation will give a good idle with decent vacuum. How much...
how about this weiand intake 166.00 head bolts,gaskets 120.00 demon carb 259.00 good set of long tube headers 250.00 instead of 400.00 rockers go...
302 thanks maverick-matt! still seems like a good deal for that kind of power. It could probably be done for less than shown in the article.
302 I was referring to the short block! It was a used short block with no mods! Although, the 5.0 HO did have forged pistons during part of the...
302 wasn't there a recent article in hot rod or car craft about a bone stock 5.0 roller with AFR heads, 4bl intake and carb with long tube...
Separate names with a comma.
