Search Results

Search Again
Page 9 of 10
  1. Mavman72
    Post

    2014 Jeep Grand Cherokee diesel. Check Engine Light keeps coming on...

    Possible bad Inst/cluster or PCM. Could be a short in the mil lamp ckt also. Issues like this (CEL on and no codes with CEL on) Tend to be one of...
    Post by: Mavman72, Oct 19, 2014 in forum: Other Automotive Tech & Talk
  2. Mavman72
    Post

    There goes my maverick money

    I agree...Put another engine in it from the J/Y and keep rollin. I feel your pain too...Been there my self,. Just remeber...Could have been worse.
    Post by: Mavman72, Oct 12, 2014 in forum: General Maverick/Comet
  3. Mavman72
    Post

    B&M shifter issue

    Have you checked the cable??? They do stretch over time...May simply need to lubricate the mechinism...Or the mechinism is getting worn out. Most...
    Post by: Mavman72, Oct 12, 2014 in forum: Technical
  4. Mavman72
    Post

    Manual trans floor hump

    Yes 69.5 had a smaller (Narrower) trans tunnel...Wont matter for what you want to do.
    Post by: Mavman72, Oct 9, 2014 in forum: General Maverick/Comet
  5. Mavman72
    Post

    Manual trans floor hump

    The tunnel is the same for stick or auto...Floor shift automatics had a bolt on floor hump to mount the shifter...Stick does not.Just cut a hole...
    Post by: Mavman72, Oct 8, 2014 in forum: General Maverick/Comet
  6. Mavman72
    Post

    What can I do to raise the rear

    Or get new springs...
    Post by: Mavman72, Oct 5, 2014 in forum: Technical
  7. Mavman72
    Post

    Looking to swap gear ratios out again

    If you go to an 8.8 or 9" you will have more work to do to make it fit but...Gear ratio selection is much better (More choices) compared to the 8"
    Post by: Mavman72, Oct 5, 2014 in forum: General Maverick/Comet
  8. Mavman72
    Post

    SOS RE: Brake Swap

    Are they new retainers??? If so...You have to knock em in with a punch/hammer.
    Post by: Mavman72, Oct 5, 2014 in forum: Technical
  9. Mavman72
    Post

    The project mav AKA The misstress...

    [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Ok so, one more go round blocking and here it is in final prime. Next on the list is...
    Post by: Mavman72, Oct 2, 2014 in forum: Maverick/Comet Projects
  10. Mavman72
    Post

    Gear Ratio

    Unless you plan to just cruise around town and not get on the highway much. 3.80 is a good ratio for these cars. (Have em in my Sprint)...
    Post by: Mavman72, Oct 2, 2014 in forum: General Maverick/Comet
  11. Mavman72
    Post

    The project mav AKA The misstress...

    [ATTACH] [ATTACH] [ATTACH] [ATTACH][ATTACH] [ATTACH] [ATTACH] [ATTACH] New digs...Started this project in 07. (Was supposed to be a simple...
    Post by: Mavman72, Sep 29, 2014 in forum: Maverick/Comet Projects
  12. Mavman72
    Post

    Air compressor with a diesel motor won't start

    Find out why he suspects air in the fuel lines. Did he change the fuel filter?? run it out of fuel?? has it been sitting for a very long time???...
    Post by: Mavman72, Sep 28, 2014 in forum: Other Automotive Tech & Talk
  13. Mavman72
    Post

    What to expect out of 4k paint job

    Hah...Rust...Thats not rust... Lucky you though...Now I see the reason for the low estimate...30 to 40 hrs of work there and it will be good to...
    Post by: Mavman72, Sep 26, 2014 in forum: Cosmetic
  14. Mavman72
    Post

    What to expect out of 4k paint job

    Well...If you want proper rust removal/repair and a show/cruise worthy paint job....expect to pay 8 to 15 K
    Post by: Mavman72, Sep 25, 2014 in forum: Cosmetic
  15. Mavman72
    Post

    New to Mavericks-Value?

    Welcome to the madness...Go buy a dodge neon or the like for cheap/reliable transportation. The mav will be reliable but it wont be cheap or easey...
    Post by: Mavman72, Sep 25, 2014 in forum: General Maverick/Comet
  16. Mavman72
    Post

    What to expect out of 4k paint job

    Expect them to fill holes (with whatever) get the body straight...Then they will top it off with a commercially acceptable paint job.
    Post by: Mavman72, Sep 25, 2014 in forum: Cosmetic
  17. Mavman72
    Post

    The project mav AKA The misstress...

    Thanks Frank!!!
    Post by: Mavman72, Sep 25, 2014 in forum: Maverick/Comet Projects
  18. Mavman72
    Post

    Paul Masson's 71 Grabber

    Looks good Paul!!! Almost there now...
    Post by: Mavman72, Sep 25, 2014 in forum: Maverick/Comet Projects
  19. Mavman72
    Post

    The project mav AKA The misstress...

    [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Time to finish up the right side...A light skim of filler to even up a few things. (Feather...
    Post by: Mavman72, Sep 24, 2014 in forum: Maverick/Comet Projects
  20. Mavman72
    Post

    The project mav AKA The misstress...

    Yup mine tooDave but... The right side also has it where the quarter meets the rocker and on the B pillar where there should have been spot welds...
    Post by: Mavman72, Sep 10, 2014 in forum: Maverick/Comet Projects
Showing results 161 to 180 of 191 Next >
Search Again
Page 9 of 10