Same stuff...Stick with rubber bushings on the strut rods,you'll be just fine.
The heim joint creates a point where the bar can move. Thus relieving the stress/bind that you get with the original and poly bushings.
Dont use poly bushings on the strut rods...Too rigid, they cause the rods to snap right where the threads end on them.
Sodium Hydroxide is the active/nasty ingredient that removes the hard anodizing...Eastwood sells a product that will remove anodizing without...
Dont clear the stuff...As you noted, it wont stick for long. There are several products on the market for protecting polished aluminum and such....
Welcome to the madness!!! I'm 60 minutes west of you...LOL...
Also...When running a carburetor with an AOD...You want your rpm at cruise speed in OD to be at least 2000 rpm...Otherwise, most carbs will still...
Welcome to the madness!!! Nice ride :thumbs2:
Since this thread has been revived...Motor wheel styled steel wheels 14x7...4" Back space plus a 1/8 inch spacer on the front to keep the side...
Nice job sorting out the bump steer and the arm mods...Yeah those vented LS1's are lighter than normal but...They go through alot of oil...
Ok, heres a few pics...Time to scrub this thing again I see...
The track is where you find the weak link...Think the axles will still get plenty of oil to the bearings with the baffles in place??? You might...
Take em out scrub em down really well...(Mr. Clean magic eraser worked very well for me) Then see what you have...I had to repaint my rear int'...
Given the cars age and exposure over the years (Colors fade with time,even white)...You will most likely have to do the whole interior if you want...
I agree but...Those general statements like that make me ask more questions.
I would use a good cyanacrolate (Crazy glue) Or a 2 part 5 minute epoxy thats water proof.
Thats the one but... I dont like the "No speedometer drive gear" statement. Its on the output shaft of the trans and really needs to be there if...
Place a want add on the forum...That will net you a 5 lug 8" you can use. As for transmissions...The ford AOD Transmission is as simple a trans...
You cant put 5 lug axles into a 4 lug housing....Axle tube/bearing dia. is smaller than a 5 lug. You are better off scrounging up a 5 lug axle and...
Welcome to the madness!!! Thats a really good looking mav!!!
Separate names with a comma.
