COOL!!! Thanks! Will have to order one!
Yes, I used the pertronix when I had a Ford distributor in my Maverick. Not sure if they make one for the little 4-cylinder tractor. If they do.... ;)
Not my Maverick...working on a different Ford. But the question would be relevant for any Maverick or Comet still running points. The sad thing...
OK, I sat back, stared at a diagram/picture of how a standard ignition system SHOULD be set up, and noticed nothing wrong. Then I relaxed and...
I have 12 volts to the + side of coil, a little less than than coming out of the - side. Wire to negative side is going to the distributor,...
THAT is the red button. Came out starting late 73 or 74 model. Most of us have bypassed it and taken out the red button and the corresponding...
My guess is somebody bypassed the seatbelt switch through there. The elusive red button seatbelt bypass switch. Disconnect the wire...if it...
You lucky bastage... :thumbs2:
And the hedman shorties fit TIGHT to the block. They would clear shock towers easily... [IMG]
FWIW...I ran Hooker 6901s on my car for years. But when I did the MII front suspension swap, there was no way they were going to fit around my...
Drop down bracket, Hooker brand. M# 10961HKR at summit. $34. [IMG]
I ran mine attached to sheet metal for a couple years. Worked fine, but loud. And louder when I got below 1/4 tank. That is the main reason I...
Running too lean accelerator pump. If it stumbles when you accelerate, and you are not seeing black smoke out the tailpipe, too lean. If it was...
Good to see he has been making them again. Hard to get one for the past couple years.
For a little more, you get a lot more with a Rod and Custom RC-106 kit (which I have installed). Coilover setup is just a little more than that....
Yes, that is the frame rail near the left rear shackle. When I had it mounted directly to the frame, the pump would cavitate when I got down...
Go low, on the frame (not body or fender panel). mount on rubber grommets. It is a noisy little pump. Here is mine when I first installed it...
Bumped?!?!? More like PLOWED! :dead:
It won't rotate. Put the full weight on the front end before you cut anymore. Once the weight is on it, cut 1/4 or 1/2 coils until it is about...
Ignore my previous post...I guess I have no idea what you guys were/are talking about...
Separate names with a comma.
