Dt Check and see what they have on the shelf. DT has been around for 40yrs. They may just have a set that only needs a little tweaking. What is...
fluid leak You do have the right dipstick? Is it blowing it out anywhere else? Rear or front seals?
trans Check the fluid level. When it got hot it probably expanded enough to be over full.
fuel cell Put it in the trunk and put the metal divider plate in there. If it gets to the point that a fire happens, that'll be the least of your...
oil filter Use the 90 deg one if at all possible and open up the oil route holes, round off the corners. Less chance for leaks or problems. If...
Aod The truck or van AOD are the best ones. Carb=rod and get all the pieces from the carb. AOD has issues fitting in the earlier Mavs. 71+ is not...
shorts What did it come out of? There was some major changes year to year.
parts The headers, compare your year Mav with a Stang's set against the part numbers. then use that info to compare with the set you have in the...
sizes Also a factor is the spring perch widths. Even thou the axle housing is the same width, the spring perches can be differnet. But those are...
plates as long as the bolt pattern is the same and the bearing opening is the same for the housing end. Other wise you have to either get new...
color personally a pewter or silver/gray color. Semi black hood and back of car. What color is the internor?
suspension Art Morrison is good people. I've been to their shop and it's impressive. They care about the customer and have good stuff.
long time Been a day or two. It's funny how people will spend megabucks on some parts, then go down to the Hardware store for nuts and bolts in...
Bolts Well said Bossmav. I remember when yours went south, north, east and west. Did you ever find the cause of the engine destroying itself?
bolts I would go with the 8740. There is such a thing as overkill in some areas. Do you need a $2000 forged steel wham bam, Thank You Mam,...
rod bolts My question is what type of rods are they going in? If it's factory stock 302s, why bother. Just get better ARP bolts. They're high...
new toy Overdrive is controled by the TV cable/rod location, speed and load on the trans. The TV cable is the big issue here and controls just...
gages :idea: Your lights sending unit will be on the same water passage as the heater hose connection is, in the front of the intake manifold....
pumping A factory fuel pump will work fine. You have to use a 3/8" min fuel line. From inside the tank to the carb. Otherwise you could have a...
gear changing Not really that hard. Easier then working on some engine stuff. I use an Inch lb torque wrench to measure preload of the bearing....
Separate names with a comma.
