Flexplate for automatic, Flywheel for Manuel. 5.0 C4 small bell= correct
If you DONT grind on them, I would be interested in buying them when you get the aluminum heads. Just so you will know, I had a set of the GT 40s...
This could be a small base circle cam designed for a non roller block. I would try to find out exactly what i had before going much further. I...
In the alternator department, You need a diode not a resistor.
Now i DID NOT SAY to buy a cheap pump. I always run the stock Ford with the regulator set at 50 psi.
If the clearnces are tight there is no need for a high volume pump, Where will all that volume of oil go? It wont, the pump will just bypass and...
Bearing and other clearances tight? If so run a standard pump, no need to put undue pressure on the distributor gear and pump shaft.
NAPA has these fittings separate, Although you will probably have to look in their GENERAL catalog. Look under the gauges and at the end of the...
I think the stock rods would be more concerned with the RPMs more than how much power( torque) you are trying to get from the motor.Unless a rod...
I'm not going to give a MINIUM safe clearance Because there would be some would say this would not be correct. But one key thing to take into...
AHH the memories, I had a 6919 in my younger years. Was a good carb. After i figured the reverse idle out. I usually just turn the float bowl...
:2thumbs: Exactly !
This is what is in mine, It has took many years of abuse, without one whimper. There is some other true lockers on the market, But they either...
DETROIT LOCKER is the ONLY TRUE Streetable Automatic POSTIVE TRACTION unit available. It will unlock when needed and will lock when needed. Its...
Pumping the lifter up WONT work, It will bleed down when the spring pressure hits it. You must make it solid. I made mine by going to the parts...
I usually just dab a little motor oil on the top of the pistons, although WD-40 would probably do the same. Remember You must make the lifter...
Aww I thought he ment BLOWER MOTOR.
If you can remove the bottom bolts with a socket (the ones around the outside that holds it to the housing),then its a 8 inch.
The T-5 which i would imagine that your talking about is a OK street trans. They will take a lot of abuse,then you will have to replace 3RD gear....
Go aluminum, Anderson motor sports, Bennett racing. can recommend a good blower cam. The AFR 185'S are a tuff head to beat out of the box. Don't...
Separate names with a comma.
