You will need to get a adapter from pipe to AN. If I'm not mistaken its 3/8 pipe to no 6 AN. I think your going to freak when you find out how...
9.5 inch converter, B&M deep cast pan, B&M trans cooler, Mine holds 13 quarts of Mobile 1 Synthetic motor oil. This is when dry. I usually tear...
Not really sure, I know the fuel tank sets off to the left, and my weight, Nitrous bottle and brackets, It also wears the left tire more than the...
In race trim ( tools and loose stuff out of trunk) Full bottole of N20, Me in the seat, Full tank of gas,RF 945, LF 933, RR 918, LR 551. Total...
Im not sure of the question, But i have 31 splined axles( 9 INCH) that use the stock axle bearings.
600 + H.P.
10k is the best we have saw, Not a excessive amount of burn outs. Usually on my car with normal to long burnouts, I can expect them to last all...
On my car the M/T drag radial hooks the best (1.46 60 foot) they do however require a different burnout, than the other radials Ive tried. As far...
If you are worried about deck height of the dist.( or up and down slack), The best way i found to check it is, Bolt down dist., Pull up to FEEL...
Im assuming a STEEL gear?
When i need a little extra clearance, i 3M two gaskets together. Never had one to leak. They also make a valve cover spacer but i think they are...
Take the old seal, Buy two (chances are you are going to ruin one) Bring seal home and check fit on converter, Pack inside seal ( where the spring...
I ran the 14x7s on the front and the 14x8s on the rear for years, Only problem i had was the back spacing on the rear. If i ran the 275x60 tires i...
Back in the days before steam cleaners and car washes.(hint) They used the crystal Drain O in a 55 gallon drum to clean blocks and such. I did...
I run the radials, which on MY car requires a different burnout than other tires. With the front tires locked i wouldn't be able to do it this...
You going to put a new seal in the front of the trans, while the engine is out?
I never really thought much about my brakes till last summer, I had made a pass on a local 1/8 mile track and had spun off the line(unprepped...
If these are roller tip rockers? Where are the rollers tracking with the ground off pedestal? This needs to be of the first concern, Then worry...
Nah i dont need the springs or rockers. Just want the heads, We have a lot of records of actual flow on a lot of heads but no GT 40s. Besides i...
You need to get the Geometry rite first,Comp sells a adjustable pushrod that you can use to measure with,( about 20 bucks last account i had) it...
Separate names with a comma.
