I really want to understand how you think I am being an ass!!!!!!!!!!!!!!! Myself, along with many others have tried to help you get this problem...
I have no problem trying to help someone that will take some advice from others. This is not the case here. It has come time to opt out of this...
Learned to drive in my dads 1965 Chevy C10 short bed. Learned to 4 wheel in my Grandfathers 66 Toyota Land Cruiser (wish I had that truck now)
All is good sir, We are on the same sheet here.
The link I posted uses a tube bulb (like the one in the dome light) not a LED. It will work perfectly.
I have installed several of these switches. In our cars if you wire it the way it says to then you will loose power to the coil powering the fuel...
Here is a test light that is perfect for your application. http://www.walmart.com/ip/Thexton-Test-Lite-Wirehawk/19257577 And hey, its at WalMart.
No, that is a LED test light. You need one with a filament bulb in it, it will draw more Amps than the one you have. The one you have is fine for...
Are you using a test light to check your connections?
OK, This thread has been going on for 2 months now. You have been given all the tools and information that you need to do the job and figure out...
They are not offered in a single pack as far as I know. It doesn't even show up on the HW website in black and yellow.
Picked one up in a 9 pack yesterday.
I do know that a electric trunk release from a Fox body Coupe will fit in a Maverick. Do not know about a hood release.
Check on Speedway's web site. They have all sorts of stuff for round track cars....
I know on my RRS system they use a bushing in the end of the column to stabilize the shaft. It is held in by a grub screw from the inside of the...
One thing is that you can use the I6 cable on the V8. You will just have some extra cable.
This had been discussed many times. Click on search and type in "window trim removal" That will get you all the info you will need.
You can mount it in there without changing the pinion angle if you cut the upper part of the tunnel brace flush with the tunnel. This will allow...
PM sent to you. If the car still has the drive shaft in it then it will work for the new set up.
http://www.jegs.com/InstallationInstructions/600/650/650-29450.pdf Here is a link to wiring your ignition system. You will use Figure #2 to wire...
Separate names with a comma.
