When you repainted it satin, what type of paint system did you use to keep it from going flat?
Just so everyone else has the info as well- Based on my measurements with stock Maverick calipers and very similar wheels, 13 3/8" ID on the wheel...
You could also just get rid of the petcock and drain through the bottom hose. Thats what I did.
I've got disc brakes with similar 14" wheels, but its very close. As in had to move the wheel weights because there wasn't enough clearance...
The PCV hose will connect to a PCV valve which simply plugs into a grommet in the top of your valve cover. The valve can be found in the "Help"...
Jegs has one.
This weekend my engine bay is getting completely overhauled. I've had my brand new shiny cherry picker just staring at me for a month. Time to...
I have access to a lift and thats how I put the T-5 in my old car. I have access to a lift, but that means loading up all my parts and driving to...
....mating a 302 to a T-5 and dropping it into the engine bay using a cherry picker? I assume I'd need a load leveler, but is this worth...
What Bryant is saying sounds exactly like what happened. Today when I started it I cranked it with the gas floored, manipulating the choke a bit...
Any suggestion on what to set the timing to specifically?
All ignition wires good, consistent spark, tight dizzy, freshly cleaned fuel system, full tank of gas. Vapor lock?
Today I finally had the time to swap out my Duraspark for an igniter III (works amazing) and swap my stuck open thermostat so my car would run...
Just ordered the Lokar cable kit. Going to attempt to adapt it to the pinto handbrake I already fabbed up for the car.
That is sickeningly clean!
If the paint is too stubborn for this, hit it with some easy off (oven cleaner) first, let it soak for 15-30 minutes, then blast it with the...
Oooh, what wheels are those?
I've got the electric version, I was pretty impressed with it as well. Used it to cut the hole in my hood. I hate doing circles with a die grinder
I've also picked up a block by the intake with all the bolts out. Damn gasket maker. I just found a spot on the front of the intake to gently...
This is more of a one off thing I plan on building for my car. I don't have the time or resources to mass produce anything. I will do a write up...
Separate names with a comma.
