No. The metal trim that you see is held to the door by a phillips screw that can only be accessed by removing(prying out)the plastic insert behind...
Yes the black plastic part comes out. The chrome rectangular piece is not just a trim. The rest of it you will see after the plastic piece is out....
The little black plastic cup comes out. I get a thin knife blade behind it on either the left or right side. I believe it has a couple of small...
Yes I have them on my '72. I bought them new in '87. The specs seems to have changed since I got mine, 30" tubes vs 34", and 8" collector vs 10"....
Hooker super comp 6110 fit with auto on column.
If you have the column shifter, it is the linkage is out of adjustment, or (what was wrong with mine) a bushing in the linkage worn out. There is...
I think they make a pcv valve that would splice into a hose. If they don't, Im sure you could rig something up. Yes the other valve cover needs a...
If you want to keep the shifter on the column, You will need the linkage with the pivot that is bolted to the frame from the v-8 car.
I had a bad starter relay that would keep the oil light on with the key off. The I terminal backfeeds 12 volts through the ignition switch to the...
around 8.35 all else being egual with a reduction of 4ccs
1966 should be 54ish.
the flasher for the turn signals is behind the instrument cluster
If you take the front bowl and metering block off the carb look for a plugged idle feed restriction. It is in the metering block on the main body...
Are you running a dual plane intake? If you are it sounds like a main jet or an idle feed is stopped up on one side of the carb.
I've run them for years that way(big hole with small axle hub) with no problems. All the aftermarket wheels I've owned had bigger holes than the hubs.
You may have a push in modulator. It uses an o-ring on the nipple that goes into the transmission for the seal. It is held in by a clamp under one...
Hey fordman I won saturday too. We were running for $700 to win in a special 1/8 mile race with $300 going to runner up, $120 to semi, $75 to...
Yeah you can take some sheet metal and cut to fit just inside the hole in the gaskets. With the gaskets on the heads the metal should stay in...
Are the nuts free to spin on the studs or are they hard to turn? If they are free to spin you will need a way of locking it in place after you...
I believe they are 3/8 fine
Separate names with a comma.
