The '80 and up will work, but the wire to the washer pump will have to be moved in the switch's harness connector to match up with the car's...
Should be o/k.
From what I can tell it looks like the pinion gear is standing up on a flat end(with no pilot).
What does the pinion gear look like? Is there a small stub called a pilot sticking out about 1" past the pinion teeth opposite the spline end? The...
Yes, just measure the outermost widest part of the gear. I just measured on old 4.11 8" ring gear and that is where I got 8".
An 8" ring gear will measure 8" at the outside diameter of the teeth. I don't believe 8" gears were ever made in 3.45 ratio factory or...
The compressor is used for removing/installing spring loaded clutch pistons under the clutch packs. There are two seals on the pistons that need...
When the timing marks on the ballancer are brought to top dead center the rotor will be pointing to either number 1 or number 6 depending on which...
If you pull the fuse your inside blower will not work.
If the rear band is applied and holding in manual low, the sprag is doing nothing. When you are in drive and in low the rear band is not applied...
I wonder if a manual bellhousing is different from an automatic? I seem to remember little strengthening ribs on either side of the bolt holes on...
I made a bracket for mine out of sheet metal. I believe it was about 1/16" thick(it was an old water pump backing plate). It used two of the...
Remove number 1 spark plug. Put your finger tightly over plug hole. Bump engine over slowly with coil wire disconnected until you feel pressure...
Book calls for 25-40, but I have never torqued mine... (just tighten good with a 3/8 ratchet).
The top push on is the trigger for the relay when you turn the key to start position. The bottom is energized when the relay is triggered for...
If you are running the fan off the push-on I terminal on the starter relay, its still pulling off the ignition wire. If you are using that...
I have installed a b&m shift improver kit. It had pretty good instructions with it.
You'll have to pull the valve body to change the shifter shaft seal(valve body will need to come out for installation of shift kit anyway)....
you will have to take the instrument cluster out to get to it. You will also have to pull off the little chrome knobs off the switch levers and...
I think thats about right give or take one year.
Separate names with a comma.
