If it is not a stock engine, and has ever been rebuilt, such as mine was...you cannot assume anything about it without verifying. Those 5.0s were...
Distributor gear needs to match the cam. So if you use the newer cam, use the newer distributor gear (and distributor, if you want). I use an old...
Use the pan, buy a used 4 bbl intake. There is no reason to jump up to a 5.0 and use a 2 bbl intake. You can get a decent intake for $100 or...
...which is good, because it most likely had the wrong oil pan, and a fuel injected intake. You would have had to scrap them both and replace.
I have an 85 block in mine. You can check out my webpage and see what all I had to do to make it work. Link below...where it says Della website...
10.10 here. Outdated, but still stable and reliable.
Try clearing your internet cache out. Internet Tools, Clear History, etc. Or get linux. No problems here!
The flex pipe also allowed me to move the exit angle of the exhaust, since I do not have a pipe bender. I pulled the tips out toward the rear...
Thanks Matterick, but I think I will be sticking with the Super44s. They are still loud, but not obnoxious inside the car anymore. As for the...
I agree. The cheap hangers and MOSTLY having it mounted to the floor. I think putting flex at both ends helped dramatically as well. Before, it...
Yeah, I was thinking of placing another set of hangers right near those flex-tubes to lift the front half up an inch or so. No reason I couldn't...
Here is what I did. 1) I bought decent bolt-on hangers, drilled and tapped a hole into my frame rail, and mounted it up. 2) Pulled out the...
OK. Pretty much FIXED THE DRONE!!. About 90% gone and easily quiet enough to drive without having to scream over it or take Vicodin afterwards to...
Mine is all slip-fit except for three bolts at collector so i can tear it down piece by piece as needed, one side or both.
Yes, I think that is the bulk of my problem. Going to put some flex at the front and rear of the setup and see if it relaxes the "tuning fork" so...
Oh yeah! I love Pink (Floyd, that is, not that hiphop chick!) When/if I get the drone to go away, I have a 12" kicker, a 600W amp, and some...
Yes, reads frequencies and Db on a graph and live-reading.
Just installed this on my phone, but should have used it before I took the exhaust all apart so I could compare before and after and after-after,...
WOW!!! That is TIGHT! I get what you are saying about just the blanks, now. I need a couple of couplers, and two of those hangers you have, and...
I just say 18" since the tube is 12" with 2-3" at each end for flanges. Unless I am not getting your gist and am way off on what I am thinking...
Separate names with a comma.
