Our October shows have been awesome, weather-wise, 100% of the time. I just hope our luck continues with the March shows. Time to mark your...
That is a nice looking car. Don't touch it. Just drive it like it is. Seldom will you find that old of a car in that nice of shape. Yes, a...
Let's see what the 4-door version looks like! :p
I ground off the bumps on the set of P heads I had. Not saying that they all had them, but the set I had did. GT40 heads also. I killed a set...
I have honestly never done that. It looks like fun! (Not the hitting the light pole one!!!). I have gone into a slide coming off an on-ramp onto...
Just the crappy bent up rear spoiler. Everyone knows a spoiler MAKES a car a "GT"! :rofl2:
Nice cross between a Comet GT and a Maverick!
Forget the camera? Use your cell phone! I wish I had pics of the copperhead infested mess I pulled my grabber parts off of. That place was SCARY!...
PICS PICS PICS!!! When you get there to see it, get pics! That is how I found my small bumpers, and all the valences, spoilers, etc for mine....
Build it! Nothing wrong with dished pistons. So you get 9:1 instead of 9.5:1. It will still make a nice motor, and just BEGGING for boost!
It is a roller motor. Roller cam. So it could be an HO. Find the casting numbers on the block and/or heads. That will help out a bit to determine...
AWESOME!!! I have an alignment issue, AGAIN, with my truck. This might be my permanent solution!
I have already installed these 3 times before. They have torqued appropriately each time. And I don't think I needed any shims. The only reason...
I did pull the spark plugs and roll the motor around when I was torquing them. And yes, I am sure this was not the source of my miss, now that I...
Mine are the Crane/Ford Racing ones. This time, I did not have any come loose enough to have play in the rocker, but they had backed off from...
I wonder if they have figured out that these are not a great idea? Crane has a different bolt setup on many of them now...The first one is what...
Alright...looking for it, but most likely will have to order online.
Edelbrock says 5.5, as high as 6. I always ran 6 with no problems. 4 is probably too low, but might work unless you have your foot into it a lot.
Shouldn't be whining at all. I would take it back. How does the fluid look and what kind of fluid are you using?
The torque isn't crucial. They are more concerned with how far the bolt turns within a torque range, so that you provide some preload. So, at...
Separate names with a comma.
