None of the above. :hmmm:
Again, what would cause THIS to break?
Good call! :clap:
I have another distributor gear and it does look alot like that, and same size. It was solid, and has broken at the holes.
What would have caused this to break?
Well, I have identified that it is on cylinder #4... How bad is the piston going to look? As I said, it ran fine the last time I drove it. Might...
So, this is where those two halves of valve locks snap into, to provide pressure to keep the valve up? Can this be replaced? I mean, can I order...
Replacing oilpan before dropping engine onto the new and I found these at the bottom. What was this? Engine has been running fine. But this...
I actually chased the threads in my heads last week for this exact reason.
I just found a couple sets of 5/16" hex head bolts on ebay and snagged them. I think those would make everything a lot easier.
I swapped the clutch-type stock differential in my Ram 1500 with a truetrac, and it has been flawless. No noise, great traction, no maintenance...
Sorry for the hassle. I have already done the legwork (at least for Hooker 6901s). I have about 6 different sets of header bolts before finally...
Never heard of the locking nuts, and don't think they would work with these. I have had a couple of the bolts walk out after a while. This last...
Instead of springs, I bent my top plate so that as I torqued down the screws that hold it to the radiator support, it sort of used a spring or...
I agree. You can snag Crane's for $16 bucks each. 1.7:1 even. model http://www.jegs.com/images/photos/200/270/270-44746-1.jpg [IMG]
the front one no problem. Most of the others wont fit. Almost all of the inner ones, under the tubes, are impossible.
Separate names with a comma.
