I like that design! Nice, simple, and very small. Most recently I used the ones with the two hooks at each end, and removed the loose hooks, and...
I was not able to keep them from walking, and also had a difficult time moving the spring into position with those hanging on the sides.
Wow! Old thread!!! :rofl2:
The reason the Caltracs are round is because you have to rotate that bar to adjust pre-load on the rear springs for launching. If it was 1X2...
OUCH! Unlucky bastridge...:cry: I didn't read the other thread and hear about his carnage. At least he had a good time doing it. So, did that...
I have one in my Ram 1500. It is silent. Works flawlessly. Never know it is there until you need it. Then 100% traction both tires. I don't...
Nice strategic Maverick Man Carbon placement on there, too!
KICKAZZ!!! Lucky bastridge!:clap:
OP is not racing. Just driving in the cold 6 months out of the year. 10-w40 has been working for him. No problem to keep using it. Unless it is...
Any oil is better than no oil... 10-w30 summer, 5-w30 winter. All my new vehicles recommend it, so why not my older vehicle?
I have a Haynes Rebuilding Ford Transmissions Manual. Covers several different transmissions, not just the C series. Complete tear-down and...
Thanks! I knew I had seen those numbers somewhere on here before, but search only brought up exhaust over axle posts, for some reason.
Hey! I still like Haynes better than Chilton. But to my knowledge, Haynes doesn't make one for Mavs. I have one for Mustang IIs and it has been...
What is the overall length of each of the 8" axles?
Yes, I just looked it up and it is a turbo diesel. If it wasn't diesel, I would be getting the 5.7 hemi, and this is only 1000 over that. And...
I heard it is going into the dodge half-tons soon. Kinda wish it was turbo-diesel, though...Not sure what I would do with around 600 ft/lbs...
2014 Jeep Grand Cherokee 4X4 and DIESEL! 420 ft/lbs torque, tows 7400 lbs, and 720 miles per tank! Anyone heard anything good or bad about...
I just hit my kill switch, but it is way around back.
I have to finish my R&C power rack and pinion setup. Meaning I need to wire the engine back up, hook up the fuel system (and nitrous kit), and...
Battery Lockout switch...what does it do? Just a kill switch for when you are working on the electronics?
Separate names with a comma.
