yes I have more........ And since T.L. likes it so much:D I'll post some more!!! I have 6 pics I will post some more. this car was put together...
Ok I recieved a phone call from this guy today.......and I know I was not the only one.....:D because he said he was calling the MCCI contacts off...
see I'm not the only one who thinks you spectators should pay......:D
You better be!!!! your old welds and my big block want to line up..........well there IS the hotel parking lot..........:D besides dave might...
Me too But I think you already knew that..........:D
I wish I were closer....... I tell ya frank it looks like you guy's down there have alot of good swap meets!!!!
I'm sure that I speak for more than myself and my family when I say our prayers are with you........and we hope you have a healthy and speedy...
there is an article on doing the rack over on ford maverick.com....I hope that it helps :)
It is located on the driver side of the block back by the fire wall.
here is a picture that was posted on mav marks chat room! mavchero????
Hey Dan I'd say by looking at the picture that it uses the acorn style nuts,because of the recessed holes around the lug nuts.:)
Personaly I like the subframe I built for mine.........as long as you don't mind them coming through the rear floor pan they make the car alot...
though the c6 is tight it did fit in my car sorry old guy but I just could'nt bring my self to put a c4 behind my 460 :D but they are one heck of...
well the easiest way I can think to explain it is the amount that the engine can rev before the tranny will fully ingauge. if you install a large...
Preston as far as how much had to be cut out under the hood.....alot!! I changed over my front end to a mustang II so in the process I no longer...
Also tom hackman put a rod and custom in tammy's car and they are running off the shelf headers. he could answer any questions you would have on...
M II If you are looking to install a factory M II front you can check the archives here and I posted pictures of my install. I am putting a 460...
that is a 460 setting in my 1974 mav
Yea Frank very snug in most places it only has a 1/4" clearance including the master cylinder.....but the motor will be mounted solid (engine...
and under the hood too even with my aluminum intake it looks like it will set low enuff:)
Separate names with a comma.
