To my knowledge, Mustangs did not use them, at least my 70 Mach does not have them.
Are those mounted upside down?
You would probably be better off getting some Pinto or Mustang II ones from ebay.
My 75 had similar wheels when I bought it. I removed them, I think it was 1 inch spacers all way round. Made the car ride like a covered wagon.
My ball joint separator has always been a BFH on the ball joint stud. There is a nut attached to the ball joint at the lower part of the spindle....
If your intake has a rear water cross over tapped for a sending unit, you can use that. For the heater hose connection I bought an elbow from a...
Got busy with the wire brushes on the Weiand Stealth intake, installed thermostat, carb studs and water elbow. Disassembled, repaired,...
I have a set for a 71 Mustang on mine. The material is of the same pattern as the Maverick headliner. The main difference is the visor end...
Nice work Stefan.
Does it come on at W.O.T. when the oil is being pushed to the back of the pan, or if you rev it in park?
If it goes out when you hit the brake it sounds like the oil is moving to the front of the pan where the oil pump pickup is located. My 302 does...
I have a 70 Mach 1, the seat backs are not the same.
The question is not will it work, it is how much will I have to do to make it work.
I had this problem on my Maverick with a 302. Mine ended up being the Hall switch (Stator) in the distributor.
I had a buddy that had his Chevy Slidro-matic trans rebuilt. They told him to use Type F in it.
You could also change the cap so that it matches the connector type on the Pro-master.
It is paid for.
I did the small bumper swap on my 75. You will want the early grill support because it extends all the way down and attaches to the valance. You...
The trick to fixing it, is to replace it. Then quit using the car to haul barbwire around on the roof luggage rack.
If the socket is bad you could remove it and replace it with a pigtail similar to the one used for the tail lights.
Separate names with a comma.
