That is the way it is on my Mustang. There is a larger hose that extends up from the tank to the cap.
My car did the same thing. The leak was from the drip rails.
You need one of these. [IMG]
On my 75 with LDO seats the passenger side does not have any spacers on the inner or outer tracks. The driver side has spacers on the inner track.
Thanks tody. That is my problem exactly. I will end up notching the tracks and the floor pans both to center up the seats, or I may move the...
So, I have a 75 LDO Maverick. I want to swap to 71 Mustang buckets as I like the style more. After removing one of the LDO seats and tracks and...
My Maverick would almost smack you in the face with the factory tension bar until I put a Grabber spoiler on it. Now it works perfect.
The installation of a ring and pinion gear requires the use of crush sleeves on the pinion gear. You crush it too much, remove and start over....
You have it correct in the picture. Old Mustangs are done the same way.
My Mustang did this once when the distributor drive gear pin sheared. It allowed the gear to rotate slightly before binding up on the shaft, but...
I would agree with what the rest are saying, find a solid newer car and convert it to small bumper. I ended up with a 75 with v8, ac, power disc...
My 75 Maverick LDO has it, but the dash is not two tone.
Installed Addco 1 1/8 front anti sway bar.
This will sound insulting but was the thermostat installed pointing in the proper direction?
Could be a vapor lock problem where the carb boils the fuel after the engine warms up. A plastic spacer under the carb is usually enough to...
I got a cheap 71-73 Mustang one off ebay. Looks like the Maverick one except the shifter is not straight but slightly angled.
My front sounds almost exactly like yours. It had a golf ball sized crater right in the center peak. To straighten and re-chrome was around...
My 75 is a bit different valve but, it comes from the heater core - to the valve - to the water pump. The other hose from the heater core goes to...
You are right Bryant. I did not want to go through all that so I just put some 15 x 7 rims on and called it a day. I will admit the the 17's...
If you have the balancer on with a timing pointer, align it to 8 - 10 btdc, or whatever you set your timing to. Then insert the distributor...
Separate names with a comma.
