Here's my piece... she's broke, but she still runs hard. ... and a picture a lady friend took while I was chewing gum at the last cruise-in.
2nd'ed on calling them "zoomies" that's what I've always heard to them referred as.
I used the pulleys off an '85 Grand Marquis and had to use an 3/8" spacer on the crank to make it all work correctly.
Her wish list: Blacked out hood with GT scoop (almost done) Chin Spoiler (nobody really knows which mustang ones will fit, it seems) New...
I bought a complete front suspension kit for a 1971 Ford Mustang from American Pony Parts for use on my car, install went off without a hitch.
306ci KB flat top pistons (with 6cc valve reliefs) eagle i-beam rods stock crank tfs stage 1 cam (.499/.510 w/1.6's) ASF 32 heat range plugs...
This was preemptive, since I replaced the cap, rotor, plugs, and wires, it has been running a lot better, but it's still not running smooth.
150 140 139 150 150 158 140 162 -------- FRONT I know the 10% rule, so I'm just barely out of that, any thoughts?
The motor: 306ci KB flat top pistons (with 6cc valve reliefs) eagle i-beam rods stock crank tfs stage 1 cam (.499/.510 w/1.6's) ASF 32 heat range...
Well, here's my day: Changed the plugs and checked the timing: no change Clean the cap and rotor off: no change Started checking each plug wire...
still gets up to RPM fine. I'll take the valve covers off tomorrow, no car show for me today.
I've got 25,000 miles on this 302 carb build. Tonight I ran it hard, no more than usual, and as I was decelerating, I felt/heard a change in the...
Calling dmhines.
There are a couple of repops, I believe the scoop is the same as the Mercury Cougar Eliminator scoop, someone can correct me on that.
Sounds like everyone had a good time. I was getting ready to head out and the '71 blew an exhaust gasket, header bolts got loose on me during the...
I was pm'ing rob that I may just try and make it on hopes and dreams. I've been driving the Maverick since my truck broke down (water pump is...
I wish I could take someone up on a ride, but I have to work at my new job until 3:15 on Friday. Sorry guys, don't think it's going to fall in...
My truck broke down today, so I'm officially out. No choice. Sorry guys.
Threads are stripped.
Still not sure on my status. I might risking driving the '71 that far with that alternator bolt held in only by locktite and hopes and dreams. If...
Separate names with a comma.
