Chewing gum might be all that is left of an old neutral safety switch.
How does it run? If the current carb runs fine, I would leave it alone and invest the money somewhere else.
OK, looking back at the pictures I took of my project... Your shaft may be moving inside the original shaft. If so, it won't affect the...
His has been cut off, and a new lower shaft has been added. I did the same thing when I installed my R&C mustang II kit. If the shaft is...
What is this humidity of which you speak???
I have never used that brand, those are nice and clean looking. I have used hundreds of the harbor freight ones, and never had any issues with...
Internet went out, so I couldn't get my work done. Went out and did the e-brake trick, but still goes down halfway on first pump, so I will order...
I will try that e-brake trick first, then order a valve if it still has the lag. I just seem to be too busy to even go into the garage for 10...
My wife finally woke up and got dressed, and did the pump-pump-pump-hold for me...:D I get up at 6 am on weekends. She sleeps in til 10. THAT...
My calipers are installed correctly. In fact, the front ones have a bleeder screw on both sides so it doesn't matter which side they are installed...
Will try this after work, and see if I can get by without the valve or a new M/C. I really need to get to a point where I don't have to spend...
Those rims with the slicks on fit just fine. I have at least 3/8" clearance all the way around the caliper. So these rims will work for the short...
Hmmm...good info. I will have to look into this next step in my snow-balled project! :rofl2: Thanks for the part number and everything!!! Makes...
It worked firm and hard with rear drums and stock front disks, and still firm after front disk upgrade. Seems like after I added the rear disks,...
M/C is Wilwood 260-8555-P From Jegs "High-pressure die casting of a premium alloy produces a high-capacity body that is lightweight, looks great,...
What is residual pressure valve? Had drums in back, and now disks, so maybe this is my issue??? The M/C is new in December 09 Wilwood. Never been...
Any idea what he paid for it, and what typical prices for something like that would be?
If I don't press the brake pedal for a few minutes, the first time I press it it goes almost to the floor. If I press it twice, it firms up...
OK, third week of the 9th year of the decade! I was guessing 99, but wasn't sure. Thanks for the link.:thumbs2:
M/T ET Streets DOT CYDV M5CX039
Separate names with a comma.
