The rear jets are a plate.....how do you read these numbers
well I have this old holley that I took apart. There are only jets in the one fule bowl. Where are the secondary jets? I'm just trying to see...
I have a 4 barrel 600cfm holley street avenger. I live in Denver and I think I need different jets/I know. from what I can see there are two...
thanks the steering linkage is all in need of attention. Do you have any good sources to send me too? I have thoes KYB shocks in front and...
First?....are gas adjust shocks, are they adjustable? if so how is this done. second?....there is a clicking from my steering....not in the...
I once bought a 1 1/8" anti-sway bar for my mav from a 68 stang. It is a good 3 or more inches too long. I'm sure that this part from a 70's...
my ride hight I just dropped a 302 in my ride and the front is still way up in the air. When I had just the six I thought of cutting a coil. I...
The c-4 holds a little over two gallons of fluid.
yea never mind.... I've never used pst springs. I was going to say, don't ket a kit. I did and it's all good. I just think I could have saved...
well I went to Colorado Mustang today and bought another FMS flex plate.....it too is imperfect. The weight on this one is only 1/16" out of...
if it's the case.. Remove the heater box and see how bad it is and clean some more.
you can also make anything too. I would use steel. I put these 85 nisan maxima power seats inf for the time being.
hi Why do you ask? I'm having a problem with my c-4 and late modle 302 swap. Is the fly wheel new?
Trashed My TransHi there....remember my starter problem?......I had to shim it. Well, The flex plate I bought from Summit....the Ford Motor Sport...
I just finnished my 302 swap and there seems to be a knocking/grinding that can be felt in the floor. Something between the trans and rear end?...
notice the door seams? that's because this picture was played with in photoshop. well, maby not...but the photo looks strange.
bucket seats!
the old school way drill holes in the shock towers. I also have the 90 deg fittings.
thanks I have a new 50oz. 157 tooth flex plate. I think the 250 had a small shim on the flex plate but it was very thin. For some reason I had...
The flex plate is facing the right direction. I can't figure it out either....unless the new start is bad too. I might add that the weight...
Separate names with a comma.
