The pan is not the best place to install the temp sender. Consider the correct 'tee' block and install it in the hot output line (close to the...
Chad, your a pistol! Iamgine that; it works like I had discribed. You must be the first one to ever do what you just did. Quite an education-...
Thanks Chad for the offer. Good luck with all your work.
Here is the info, where to find the info and where to get a relay. The designation is DY-865. Ford part F9PZ-14N135-BA as looked up by my Ford...
I will check with my parts man to see what he comes up with for a part number. For those who have the Fuel Injection book by Probst, check page...
Now your getting somewhere. In my post 16, I mentioned that the engine could not be an FI engine. You already have the Dura spark dist. The...
A search of online auto parts sites shows that no one lists the EEC power relays. Suggest you go to a Ford dealer and ask them to look up the...
The relay your talking of operating and releasing is not the EEC relay. It's for the fuel pump circuit, but is operated by the EEC, from the...
To your 351 question, yes the 5L upper will fit the 351 lower EFI manifold as long as the port mating shapes are the same. Also some larger cars...
The original wiring with coil ignition has two leads. The start lead bypasses the dropping resistor for starting then switches over to the lead...
What are we calling 'drop in voltage'? EEC power up for starting and running?
Some one has already changed it over then because carbs and CFI were all gone by about 86
To add to this, ever notice an open rear almost always loses traction on the right rear tire? This is because the pinion tries to climb the ring...
No, the length is to short and the end to the oil pump drive shaft is to small. Use 351w dist. only with Dura Spark pickup and centrifigal advance...
Why are we not hooking up the system as it is supposed to be? The EEC is powered at all times even when the ignition is off, in all cars and...
An 89 is a fuel injection distributor. It has a Hall Effects sensor (pip). These generally will not fire a Dura Spark box and plus it has no...
Your question about the EEC differences are that yes there are differences in options, timing curves vs weight, and in genral applications year to...
If you look at pin 22 off the EEC and follow it, you can see it goes to the Test connector, and the Fuel pump relay. This is where the ground...
Fuel pump operation for fuel injection is initially started at power up thru the ignition switch. This pulses a turn-on on circuit in the EEC...
Both systems use VSS signal. All the latest cars and trucks still use it. In the case of integrated cruise control, VSS is used for very...
Separate names with a comma.
