I tore it down to the block with the crank and pistons still in it .No rust at all in the motor. I replaced every gasket you can on the motor. I...
well the story on this engine is this - my dad built it about 10 years ago and put it in the mav , well his health took a down turn , long story...
how much blow-by could be expected with those compression scores ? I have been told it could have bent a push rod? or The oil pump that is in it...
me and my friend mess around with it again today , its smoking out of both sides , just could not see it due to the driveway the other day . I...
its blue smoke , does not really do it at fist start but maybe a min into it idle a constant haze out the right side .
Ok my 302 is smoking pretty hard out of the drivers side, I did a compression test and all the pistons came back at 135-139 psi I put new stem...
I'm running 93 mustang power buckets in mine , I cut 4 inch steel pipe and welded it to the floor , took a half inch thick bit of steel and welded...
will an AOD out of a 80's LTD crown vic work , also the cross member does it work ?
Will an aod work with the c4 drive shaft ?
I have been talked into keeping my C4 trans, however the rear end in my 73 is too slow. The car was a 6cly from the factory and is now a v8 302...
Thank you sir ! all I needed to know .
Hello guys , My 73 has a C4 trans with a shift kit/ slap stick set up < that I hate ! ... I have a 1990 donor f150 with a good 5 speed in it ,...
missions complete
in the process of putting the font back on
me and a friend spraying the mav
Separate names with a comma.
