I'm confused right after you said to fold it so it's double thickness. and do you mean a butt connector? I found this picture and was wondering if...
I went out and looked and the wire pulled out of the connector:slap: I couldn't even tell because of the other wires on the solenoid. Anyway, I...
I have replaced them in the past, but my question to you is how am i going to replace this particular wire?? Like i said it's 1 wire and splits...
yea that's the link we were just talking about. it's a thick wire that goes into the link and then a yellow and black with orange stripe wire...
damn you've got an eye. i took a closer look at that wire and it IS open on the other end. it doesn't come apart though. I have a wiring diagram...
On my way to Turkey Rod Run.
it's still charging but the starter is still just spinning. solenoid gone bad?? which one is the exciter wire? the 2 wires that hang to the right...
They look fine. Don't they melt?
I can't even make it down there. I've had the car on the trickle charger for a few hours now and the battery is up to 12.20 volts and the starter...
You want me to check the alternator amp output? Alternator is new as well.
This is a brand new Interstate battery located in the trunk. I have noticed the more I drive the car, the weaker it is to start up. I just had to...
a kia soul...:slap: 16 hours...:slap:
Yup I was just there yesterday with mine.
yea i think that's the guy with camaro tail lights
I need a shifter boot for my 3 speed. The Mr. gasket one they sell at Advance is too wide. Will a Mustang shifter boot C9ZZ-7277-A fit?
Ok I finished this up last night. I used the nuts like you guys said. It seems to operate smoothly and I will get it 100% later. The only problem...
in ohio? i wish.
Do I have to use the throttle cable adjuster nuts that come with it? I have the factory metal sleeve that's already wedged in the throttle bracket...
you can also get a paintable chipguard. they come in different textures from smooth to rough.
Separate names with a comma.
