It will trigger the check engine light if something is not there to fool the computer in thinking the EGR is active or there. If you was to unplug...
Oh yeah! Fire dept on stand by! LOL! Ive looked bout everywhere to find a triggering device without a computer,, but heck I am not spending...
Yep! I did that once to a Jeep, and watched the smoke roll from the alt! Chad
For the wiring diagrams,,, WWW.FORDFUELINJECTION.COM will have every diagram you need. Chad
Rick, its a tractor! A 1958 Farmall 460 with a C-301 6 cyl IH gas engine. The computer controls the negative side of the componets. MSD does the...
What would regualte the voltage? or is it full amp potential all the time? Im worried bout overcharging the battery. Chad
The signal speeds up as rpms increase, signal slows down as rpms decrease. I will control how much fuel enters by setting the fuel rail pressure...
Here is the trick on the IGN circuit,,,,,, the computer runs the negative side of the coil, the hot +12 volt is to a key switched power source,,,...
Im thinking if Ican borrow the trigger signal from the distributor, hook the MSD up to that connection,,, the MSD might power the injectors with...
Rick! I built a EFI fuel rail for a 50's 6 cyl engine with ford injectors. I figured,, that if a MSD's multiple pulse discharge works on a 12V...
I did the same on my 88 engine,,, I think it makes the alt run a peak power at all times instead of a regulated steady increase or decrease in...
Sounds like your just using the ALT to charge the battery,,, its more meant to run accesories. You might get away with running a second wire to...
hey guys! Do you think its possible to use a MSD 6AL to operate fuel injectors instead of an IGN coil? Does anyone have the amp/voltage outputs...
MM, Im running a 88 SD 5.0 in my 69.5. The hard part is the wiring, but it is very easy to do!!! Think of each wire, like a highway,,, each wire...
Borrowed Rick! Borrowed!! The ranger has Mass air,,,, few extra wires here, and there, and made the Speed density into a MASS air EFI. In the...
My 88 roller 5.0 is 150 psi across the boards. Rick, I pulled the injection system off the maverick and put it in a 95 ranger with a 5.0. IT...
Stroke the crank 1/8 inch, machine off the tops of the pistons .0645. it will be a pretty stout little motor. Probably get it built for around a...
Yep, you gotta run the return line from the fuel rail back tothe tank. 50psi rubber line works fine for this,, You can zip tie it underneath...
I built my own pump for my efi maverick. I did not have to cut the tank to put in a pump, just run a return line and I was done! I had built a...
Idaho, I have a 88 5.0 in my 69.5, everything is from a t-bird. Before I took the engine out of the ol bird, I had ran the cable unhooked from the...
Separate names with a comma.
