If the solenoid is the original equipment, and not dura spark, there are two small wires attached, one is red/blue and is powered during start...
I like the grunt of my 3.55's but if I were to do it again, I would use the 3.25's for fuel economy. That 351 of yours makes tons of torque, it...
All good advice. I ended up using some cheap 4 position fuse holders that used crimp on terminals that could be separated if necessary for...
Run an accessory feed wire to the interior from the solenoid or battery positive cable, like a 12 or 10 ga cable to a isolator stud and attach the...
the one on the right is usually cooled by ambient air(no fan) and the stacked plate is normally mounted somewhere in front of the radiator so that...
Welcome from GA:tiphat:
sounds like sound advice. I'll check back later.:yup:
Yea, diagnosis would be your friend, not shotgun repairs. Rewiring the car would be very frustrating just to find out the fuel tank had trash or...
I'm with Jsarnold on the headlight relay. I had repeat switch failures and broke down and installed the relays and WOW, what a difference! Check...
You could but I would run a dedicated temp switch for the trans fluid. When it's cool, you need the trans fluid to warm slightly and just because...
Possible, but doubtful. Sounds like the conditions that caused your issue are not present at the moment. If it does it again, you need to...
My timing chain did this to me a few months after I bought the car. The plastic gear sheared off about half of its teeth. Ran fine prior to and...
That comment was more questionable humor than a reason to not do it. :D For what it's worth, There is one in my neighborhood that the storm drain...
[ATTACH] Just convert it to EFI...:hiding: I did, however, find the shortcoming in using ram air in that location for a daily...
Welcome from GA!:tiphat:
No problem resurfacing here either. There is usually a small chamfer around the edge of the flywheel friction surface. A good Joe Six-pack method...
Welcome from GA!:cheers: I have a 5.0l EFI that has been a daily driver since 2000. Good luck!:thumbsup:
I have a set of the conventional long pattern ratcheting wrenches that EZRed makes and they are fantastic! I would be willing to give them a try....
Love the stance! Great color!:2thumbs: The belt drive on the Mustang is very cool too!
That's it!:thumbsup:
Separate names with a comma.
