If you read the instructions for the aluminium intake,weiand,Holley, etc. They thell you not to use the cork or rubber end gasket and run a 1/4"...
Had the same problem with the 302 Mav that I bought a few years ago, the car had low milage but had been sitting in a garage for a long time. I...
The Summit part number for 2 complete backing plates is FMS-M-2209-B and FMS-M-1126-B is the drum number. After making a call the bad news is this...
I need to do a total redo My rear brakes on my 73 and was checking out my options and came across Ford racing M-2209-B backing plate kit and...
I vote for 10:1, there is nothing like the sound of a engine with a mild cam (slight lope)and higher compression :) . Alot of the factory cars of...
Things to help make more room, you can remove the tie down rings around the rear of the leaf spring if your car has them, the driver side gas tank...
Its tight but 2 1/2" all the way back will fit, I have 2 1/2" all the way with x pipe and Flowmaster series 50 mufflers (did have the original...
They do look similar, headman shorties have 1 1/2" tubes the Patriots have 1 5/8" tubes.
I bought a set of these when when they first came out to see if they would work on gt40p heads and #8 spark plug was no go, also tried to install...
If the weather is good I may stop by but not with the Maverick, its up on a 4 post lift and I have a car apart under it.
I think that the 30180 is a kit that includes alt bracket and tensioner, the 1675(high water flow) and 1670 (performance) are just the pulleys...
I use a 670 street avenger on a 331 and it works very well and I would recommend getting the vacuum secondary spring kit to fine tune how fast...
I'm located below the canal also refered to as lower slower Delaware, not many Mavericks around here at least on the road. There was a guy who was...
1/8" camshaft endplay some things to look for Thrust plate worn or back of timing gear (usally caused from 0 endplay at install or lack of...
There is three 3/16" holes (intake side) on the head gasket for each cylinder, the older block and heads use the center hole, newer heads use one...
I'll be there Fri-Sat with full rain gear (I hope I don't have to use it this year):) ,This time I'm driving the Mav. up :bouncy: and hopefully...
A 160 deg. thermostat is a good choice but make sure its high flow or performance type as mentioned before, it does make a difference. The other...
I finally got the FPA gt40p/dart tri-y's installed, the passenger side went right in fits perfect, the driver side I had to remove the pitman arm...
I did a Scat 331 stroker and the rod bolt nuts were about .005 from hitting the bottom of the cylinder bore (if you upgrade to larger rod bolts it...
I ordered Tri-y's from Fordpowertrain made for dart and P heads, from what I hear someone in the midwest has them on a Mav. I'll be getting them...
Separate names with a comma.
