mine looked about the same, except i did over the whole wheel well, inner well and infront of the wheel well... I found, the larger the piece the...
sounds like a deal to me! I went down to pick-up my new cam and they tried to charge me 50 bucks more than they quoted and told me they were...
just went to the site and had a look right now, says 8" rim, tires section width is 10.5, tread is only 8.3..probably why it doesnt look bad...
his looked fine and i had a set of 7" prostars here i really like :( guess i should go see what i can get for a decent price...would still like to...
My brother has run then on 7 inch rims on his mustang and they look proper and how they should sidewall bulge and such, his car runs in the 11's...
that looks good..if i recall you were having welder issues..turned out awesome, wish i had all of that stuff infront of me though, could basically...
lookin good..wish i welded up the cowl when i did my car...anyways, if your going to a C4 and a high trans tunnel like that, think about the...
looks amazing...is that The R&C kit?
now that you mention it i remember having the trim the engine block plate..i think your exhaust should be able to clear that ear though..take a...
oh dang...well these had red loc-tite on em!
Do they have factory loc-title on them? Red is what was on them.. I used some move it and cleaned threads, put the LCA's on. impact wouldn't move...
i finally finished up my engine bay wiring tonight, so probably sunday ill throw on the arms and if i cant just rattle them off, they will be cut...
that may be why...i still got my old control arms, ill throw them on this weekend and rattle the rods off! thanks for that tip.
get rid of them all and switch to a taurus fan, you will both be extremely happy. it cools my engine no problem, fits amazing and was very little...
am going to try what craig said....since he's taken about 972.5 of these cars apart and i stated that because its not "frozen" to the bushing. i...
well i was cranking on them, put some heat on them and wont budge? then if i just wrench the one side it'll spin inside the bushing..should i just...
There was a bracket that didnt work with my shifterr, and i believe in the instructions it told me to cut it off. pretty sure that may have been...
Looking good, hope to see you making a lot more progress over the winter. & i also used the paint stripper for that, worked great.
i have procar sportsman seats...would really like to switch to a nice highback bucket maybe from a mustang or 70's camaro or something..
looks good. but i really hope you cleaned that tranny before it went in!
Separate names with a comma.
