more pics More pictures
Top shock mount in I got the top shock mount in, it is installed so that the shock at ride height will be 14". I left the ears long so that I can...
You have to check the voltage on the wire with a volt meter, it is only 6 to 7 volts. Check out this link:...
Actually this mount is just for test fitting, I will be making the mount out of 1/4" wall square tubing and 1/4" thick tabs, good eye though! I am...
Progress so far Both bars are now in and welded. The drivers side took anout 4 hours between the test fitting and notching and test fitting...
pic of wires close to hole Pic of the wires close to hole
progress update Bent the drivers side front bar this morning, cut the hole in the firewall the same place as the passenger side. Inside there is...
I sent in an e-mail, any update on these?
Both sides finished and welded in Both sides are in enough to take it to the alignment shop next week for a quick check to make sure everything...
I took a friends car out today that has +11 degrees caster and drove it around town, drives comfortable enough to play on the street, mainly all I...
Progress today I got the right bar attach point welded in and the bar mounted and welded. I plated the front attach point with 1/8th and welded...
These are the measurments I have so far, and this is with everything in the center of its travel, so there is quite a bit of room for adjustments....
Caster/camber I have found out that with the stock steering box and doing the shelby drop the max caster I can get is +7 degrees because of the...
I will have answers for all of your questions soon. Wanted to do a quick reply to let you know. My girlfriend thinks I am a bad influence as...
I took a bunch of different measurements from several locations before I cut the car. Even then I still missed a couple and have had to measure...
latest progress I have the right side mocked up and have been checking caster/camber settings. I have lowered the upper control arm (shelby drop)...
Thanks, and I will for sure keep you updated on the cost and time it takes. I have about 210.00 in materials and about 9 hours labor so far, not...
It definetely sounds like the holes should be raised, "drop" seems like you should raise the holes to do that, like you are dropping (lowering)...
I took a lot of pictures and a bunch of measurements. I am using Volare upper ball joints, they have the same taper but you have to drill the...
Separate names with a comma.
