I don't remember which cable is which, didn't mix up the two cables at the box?
:Welcome: from south central PA.
I would use a long jumper wire to go from the last known good voltage point and connect to where you should have voltage and see if that works.
When removing the cluster I even loosen the two bolts holding the steering column to the dash so the column drops down to get more clearance.
Yep, thanks to carburetors fuel washing the cylinders a causing carbon buildup elsewhere most engines didn't last near that long.
Any chance the outer ring has slipped on the crank damper?
If it backfires through the carb the plug is firing while the intake valve is open instead of after it closes and the cylinder builds...
:Welcome: An adjustable timing chain might help some with the compression some as the stockers had retarded cam timing. But that's probably a D4...
If you need just a small amount of clearance to the leaf springs you can add wheel spacers. Here in PA we're allowed up to 1/4" thick spacers. I...
Natural gas heater in my uninsulated 2-car garage. Don't remember if it's 20k or 30k BTU but it gets stupid hot in no time. It's probably too big...
Same sizes here. I did find on the front, with a lot of backspace (4"), it has less leverage on the spring and caused the car to sit higher.
When mine started doing that I cleaned them with acetone and then sprayed with rattle can of plastic dye I got from off the shelf somewhere local...
Mine are like this but here in PA we're only allowed amber or white lights on the front of a vehicle so I want to put amber LED's in place of the...
Don't remember what brand mine were, they're all over evilbay. These are very similar, Cree LED's, 6000K color temperature, fan cooled:...
:Welcome: I'm kinda partial to Grabber Blue '70's.
When I did mine I started 1/2" or so inboard of the bolt hole for the firewall brace and dropped straight down until about an inch above the...
I converted to H4's a long time ago. Now I have LED bulbs that screw in in place of the halogen bulbs. Plug 'n play. [IMG]
Spark plugs have been getting screwy for the past few years. I ran mostly Autolites and some Champions for 50 years without problems. Last set of...
You can set initial ignition timing statically without the engine running. Bring #1 cylinder to TDC on the compression stroke, then set the...
You need air, fuel, timing (valve & ignition), and compression for an engine to run. One of them has to be off. Air is easy, fuel-I'm guessing...
Separate names with a comma.
