Took in the Wednesday night Show N Shine then cruised to the Dairy Queen. [ATTACH]
Still needs a bit of touchup but much better. [ATTACH]
[ATTACH] [ATTACH] I would vote to replace the charcoal canister and restore the lines. Although emissions related I don’t think it inhibits...
Here is a listing for the Mustang rear ends. [ATTACH]
I was just wondering, aren't these the exact same 140 HP engines? Depending on the data source, the 73 Mustang with the base 302 did 0-60 in 8.8...
I went back to priming and painting some smaller areas, one under hood area on the driver’s side fender and a spot inside each of the two doors,...
I primed and put the first coat of paint on a rust repair under the hood on the driver’s side fender and two spots inside the doors. It’s cosmetic...
Yes, I imagine the pan got stripped at one point.
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] I installed compression fittings on the 5/16 steel transmission lines and crossed over to rubber...
I carefully drained the fresh oil into a clean container then dropped the oil plug and re-ran it with a Dorman plastic washer with concentric...
[ATTACH] I installed the Derale brand compression fittings on the 5/16 OD steel transmission lines. The hose went to onto the 3/8 “ barb...
Installed the 5/16 transmission line compression fittings with the 3/8”OD hose fitting. Went well and no leaks.
Drained the oil, changed out the oil plug seal. The blue Dorman plastic washer with the concentric ribs worked fine. No more drips. [ATTACH]
Thanks for the update. With other demands on your time it’s perfectly normally to work one your car in sprints. Keep it rolling!
My parts for the 5/16 transmission line to rubber lines arrived. [ATTACH]
The Dwell/Tack arrived. It comes with an induction pickup to clip on a spark plug wire for RPM. [ATTACH]
On some, even though the choke is set, you might have to give it some gas for a while.
Well, I picked up this digital model, it’s mostly the tach and dwell features I want for tuneups. [ATTACH]
After having no luck in town I ordered up two these 5/16 compression by 3/8” barb fittings. Price is CDN dollars. One good thing is I don’t have...
Thanks everyone, so I can do a single flare on the 5/16 steel tube, ( not forgetting to put the nut over top), connect it to a AN 6 fitting with a...
Separate names with a comma.
