http://www.carburetor-parts.com/Autolite-Motorcraft-Carburetor-Main-Jet_p_175.html
What is the OE part number? By the way how far out are the mixture screws?
Holley remands carbs and has the correct specifications.
Adding extra cooling capacity.
I was just curious if anyone had tried it. Lots of pluming, but you could put a couple cores almost anywhere. I was thinking in an addition to a...
Same reason you turn on the heater if your car gets hot. Adding extra cooling capacity.
Is this based on the OE part #? 888-465-5395 Holley remand service can tell you what the original jet size is and all the original specifications....
When you tuned the carburetor was the engine at normal operating temperature? What jets are you running? 4100 is a very good carburetor.
Ok, I don’t have a cooling issue, but was thinking has anyone run an extra auxiliary heater core(s) in the front of the car when space is limited?...
Thanks....
Why is there a two hole and a four hole lower control arm?...
Is there a part number on the spindle?
Fox bodies have a double sump pan.
If it was me I would get a 9 inch out of a GMV with a 2.47 gears and install an old school performance wide ratio 4 speed with a deep 1st gear....
AutoZone shows the same thing. 5 on 4.5. Only used for four model years plus the hardware is same as my 9 inch Granada rear end.
Should it not all be the same? Looks the same except the F-100 shoes are wider and the drum lining extends to the bolt face. I thought the same...
Any one tried the F-100 brake conversion using 82 F-100 drums and shoes? F-100 has a smaller bolt pattern than the Bronco and F-150 but uses10...
Yes I have, try the Distributor Ignition Pickup
Thanks. If I use the E-150 springs, can I get bushings that have the smaller bolt hole? Spacer?
Sweet! How high will this lift the rear end? What is the (A/B) measurement?
Separate names with a comma.
