will a 17x8 and 18x8 both with 4.5 backspacing work? even with a lowered car?
i can not find a cheaper bracket that will fit my motor. the one for the later 351 doesnt fit or i dont knwo how to install it... if anyone has a...
i came across a really good deal on a 9 inch, and it has a 5-4.25 bolt pattern? its 57.5 inches mounting surface to mounting surface. would it be...
i got a crank kit and had the motor all together and was checking the clearances and starting in the front of the motor the rods are .003 and as...
heres a couple pics of it out. still cleaning it and installing the wiring
I got a 98 gtp console same as the base modle but with a seat heater switch. I mocked it up yesterday and it looks pretty good but if you have the...
well since i didn't want to pay the $600 for a set of custom headers or the ones offered by other companies i made some work. i used a set of...
Yea I installed it 0-0 but he said something about haveing the #1 cyl at tdc when the timing chain goes on...
I talked to my mechanic and he said it's probaly timing Ana he said something about the timing chain being at 6 with the crank at 12 witch is what...
i got a new crank and pistons in my car with a set of headers. and im trying to start it and it wont start turns over and acts like its going to...
oriellys and advanced both have to special order them and don't know the how they have been ground
im in need of a new crank for a 351w mine needs to be turned, its gouging the bearing down to the copper. so does anyone got a good crank or know...
if its a ho 5.0 do what car craft did and put a set of afr heads, got the article said with just the heads it made 400hp i dont know what it would...
so i found that the motor will shake like hell if its a flywheel or balancer and it only shakes when 2000-2300 rpm. so he thinks the piston is in...
took the car into a ford mechanic today and says my engine is vibrating, not a lot but it will destroy a bearing, he says it might be the fly...
getting an edelbrock :). so im selling this one if your interested
if both screws are are in the engine dies, i was told and read that the normal is 1.5 turns on the mixture screws on the metering block, the bowls...
nope i got the normal screws the carb is a holley 600cfm 80145, any help would be great for tuning this its a double pumper with vacuum...
reset the timing to 25 total timing. i tried to set initial but i cant figure it out. i guess my carb is plugged, when you screw one mixture...
i have a holley list number 80145. and my car is running very rich, smell it on your clothes burning you eyes rich. its a 351w, edelbrock...
Separate names with a comma.
