I'll have to think about this comment. Maybe you are right?!?!?!
All wiring outside the cab (front and rear is custom). I tapped into the original cab wiring at the bulkhead connector (Inside wires looked...
Yep, just too impatient!
The custom rewiring was a nightmare. I'm still not 100% sure everything is right, but it finally seems to be working OK (thanks to all the forum...
After a rough alignment, it's the first time on the road since 1983 for this Maverick! A long way to go, but getting there. [ATTACH]
Maybe this helps?
I think I have answered my question. I found this on a 1970's era ford truck site: The fuel sending unit operates off a 5-volt pulse supplied by...
Nice to be outside again. I roughed in my new ACC carpet. The fit looks manageable. I may need some help with trimming details on the edges...
I've recently "completed" a major overhaul on my wiring. Everything checks out fine :bouncy: except the fuel sender wire has an oscillating 12V -...
Thanks, good news ! I really did not want to send this back. I want a carpet, I'll work with it. My mistake. Rock Auto advertised 2 door...
Can someone tell me if I did or didn't make a mistake here. I have a 1972 Maverick grabber with automatic tranny and stock floor shifter. I...
Here is the oil level with 4 quarts of "oil" in a stock 302 pan: [ATTACH]
Tom, Thanks, I have an old oil pan and will add the 4 quarts of water and see where I end up. My rebuilt engine oil pan looks close enough to...
Does anyone know the oil level recommended for a 302 referenced to the oil pan flange? I see all kinds of posts about quarts of oil etc. , but...
Today I finished phase 1 of my custom wiring job (all wires were run outside the engine bay vs using the bulkhead connector). Great to hear that...
Thanks, this confirms my 2 hours of unsuccessfully trying every option from the front. But, I did finally get it in from the backside with bezel...
Never mind, I see Melvin's has them. Off they come. P/N C9ZZ18519A. How about an HVAC control panel, without A/C, I don't see that at Melvins.
Thanks for the info (yes, they appear to be glued on, they are not falling off). The heat shrink sounds like a good idea. Do you know of any new...
Thanks, but I got it figured out without any help... finally! It goes in from the back, not the front. I'm not sure why I didn't think of it...
Can anyone tell me how to get the hvac control switch in. It just does not seem to fit anyway. If the silver knobs come off, it would be easy,...
Separate names with a comma.
