We need a photo of a 72 gt steering wheel, ours had a grant on it but it's too small in diameter, and I can't read the speedo, Anyone out there...
Definetely the instrument panel. Those little fuses aren't too easy to come by here in my part of the country.
what kind of RPM's should I expect from a 302 with c-4 and 3.00 gears at 55 or 60 mph?
I unscrewed the modulator up to 6 turns with no change. It shifts from 1st about 15 mph. I put the modulator with the white stripe which is what...
I have not had the transmission unhooked from the car during my overhaul of the 302, initially it would slip from 2nd to 3rd usually high rpms...
reverse and manual low seem fine.
I did not fill the transmission while running. A couple quarts leaked out during the rebuild of the motor. It shifts eratically from 1st to second...
I just got my 302 rebuilt, I had a dead miss on No. 4, found the vac. line off at the modulator. Now on my first run it slips big time in high...
We finally got the new 302 fired up. Bored .040 with flattops and a edelbrock carb and intake. Did have some trouble getting all the air out of...
Anyone have any luck running Edelbrock intake with stock FEL Pro gaskets. I didn't want to buy another set if these would work.
Any watch outs on a new install of a stock timing set on a 302? Are they hard to get in time?
Will c4 kickdown linkage hook to A Edelbrock 600 with the ford linkage Edelbrock offers to bolt on the 600? Thanks I've got tons of questions
can the plate that holds the cam in on a 302 be put on wrong? I'm trying to cover all the bases before final assembly. How much horsepower will a...
so if I understand correctly, the rod bearings tabs will be oriented on the same side of the rod rather than across to other side of rod.
Do the tabs on the rod bearings on a 302 install opposite sides of each other, or on the same side of the rod and cap? Thanks
Does a 72 302 have adjustable valves? Also I'm building a 302 that was apart, Does the rod numbers punched in the side of the cap correspond with...
Just pulled the tired 302 out of the Comet, We are going to install a performer 289 intake and edelbrock 500cfm carb, my question is manual or...
the last 302 I built I used a mild cam that wasn't supposed to affect idle, but after I replaced my Harmonic Balancer the idle was still not as...
I installed accell electronic ignition, I did not remove the distributor. When I started I put the harmonic balancer to tdc and rotor pointed to...
Our c-4 doesn't shift out of 2nd, and has a pretty rough grinding you feel in the floor when you put it in gear. Are we better off to rebuild or...
Separate names with a comma.
