Nice update, Frank! Too bad about the limited availability for E85. As you already know.. turbos love the stuff and your tuneup improves in...
I'm with Mike all the way here. Clearcoating adds more steps.. therefor more cost and chances for mistakes and contamination. SMS has your...
Yeah.. seen that one before. Thanks for the lead. Ideally I want a very small and subtle cowl added to the rear of the hood but intend to keep...
You can lose them if you want. Plenty of other ways and locations to lift it later on if needed. Do as you said cut and run shorter bolts to...
Look around for some plastic lined sockets made especially for alloy wheels. I also know a guy that uses shrink wrap on his sockets after being...
Holy crapola.. that's the kinda stuff drag racer types dream about at night! Should be able to shed upwards of 100+lbs off the nose with that...
What a rip off for an am radio! I remember my 68 Mustang GT having the rare and highly sought after 8 track tape option. Actually sounded pretty...
Man that brings back memories! Remember pumping up the ole' air shocks when extra company showed up? And remember when one of them popped or...
Sorry to hear that. Pack everything up nice and tight so it's ready again when you are. Good luck with everything!
Driven in many fast cars and there's a huge driving difference between a centrifugal and roots. Outright power from start to finish with a roots...
Nice! How much power did that mod add to start beating up on those little v8's?
Friendly word of advice when it starts going back together.. be sure to use thread sealer on all crank to flywheel bolts. They run straight thru...
Duh.. just noticed the tire sizes and thunk about it again. A 205/50/17 is only 25" diameter with really square sidewalls due to aspect ratio....
Inspection plate can be removed
Thanks Frank!.. I'll try to remember that. :) Do 8" rims with 4" backspace, instead of 4.5", come that close to hitting the rear fender lip?
Can also use a large flat tipped screwdriver on the starter ring gear while torqing to spec
Through the starter hole
Are you using the crank bolt to drive the balancer on.. or the specialty tool which has a bearing on it? Not using the right tool can be...
I wouldn't sweat it too much since there are tons of various sized wheel spacers out there these days(preferably billet due to strength) which...
After 5 years of use without issues.. I'd say you are gonna be fine over the long run. High output/high cylinder pressure motors are much less...
Separate names with a comma.
