Other things you might check before tossing parts at this issue. Remove belt and check wear patterns on all pulleys. With belt removed check...
I have a couple comments. First one is relating to the need for the gilmore setup vs the conventional v groove or the serpentine setups. Many...
I hear you there. IIRC, and likely not, it was something around .020" slot adjustment per crank degree. Just numbers stuck in my head.. could...
If you read back to my first response about heavy initial advance and bigger cams you can imagine you're still leaving tons of manifold vacuum on...
At one time or another I and just about everyone else has done that too and they never last nearly as long as doing full tilt higher caliber...
I fully agree with this. Just keep in mind that finding the optimum locked timing number is always going to be a matter of robbing peter to pay...
The arning/shelby drops typically help the camber most of all but will also help the castor gain a bit moreso on the compression phase of a-arm...
Nice solid combo. Based on that info here's what I would do. Solder or weld the slots to achieve a minimal centrifugal sweep of around 8-10...
Thnaks for the follow up reply. Mental notes taken and filed away for future use. Hopefully I can remember later on which mental cabinet I...
Your timing for those cylinder heads and compression ratio does seem a tad high. Most with similar combo's I've tuned or seen tuned(or even read...
veddy intedesting. The width of the early stangs bar was similar enough to our cars that no additional mod's were required? No mod'd spacers or...
Hadn't seen the brush on stuff yet. Pretty cool. Looked through their website and couldn't believe the pricing for non-catalyzed supporting...
Been looking ahead towards my next projects and going through some of my suspension links lately and forgot to mention the "street or track" stuff...
Not to say that you can't go direct to metal(DTM) with caliper paints, I've done it many times in a pinch or as a quick bandaid to hide rust....
Who needs cad drawings with Bob around here. Lol Also why I enjoy this place with so many people willing to go out of their way for others who...
Thanks Nick! Will have a look around the parts yards to see if I can make them work for my Comet too.
LOL.. after all that restoration work on that rear housing you'd think you'd be worn out for a few more weeks. More power to ya though! And I...
You should search a little harder using early Mustangs as a cross reference.. because there are several besides the one listed above. Probably...
Yeah.. awesome car! Love the color too. No problem finding that car in a parking lot. Quick question.. what seats are those? Thanks, Greg
I'm not sure if it's the same car or not but bssed on your location there is a member here named "skeeter___".. not sure of ending to his signin...
Separate names with a comma.
