Thanks Dave, I was hoping you would chime in.. Why all the fuss about the billet "H" the shop is "strongly" reccommending? (besides their mark-up!)
Having the work done today. I am installing the TCI kit but my question is on the servo. I read a lot on this board about going to a "C" or an "H"...
That explains a lot Ray..LOL
For hyd I have always used a valve cover with the top cur off. With the engine running loosen the nut until the lifter ticks, then tighten 1/...
any other photos? I am frustrated with the pig tail of wires..Scott
Since the shortblock is in the shop I wanted to clean up the compartment a little. Can someone post a pic of the area around the master cylinder?...
Terry, am I gonna owe you a commission? Thanks for the shameless plug!!
I paid less than 500 for 2 1/2", flowmaster 40's dumping in front of the axle though..
Dave, I always appreciate your posts! I did not mean to offend by the "ball" comment. I installed a BM kit a long time ago. Loved the change! Just...
With patience I found a set of Edelbrock RPM heads on EBAY for less than $800. I MAY have a set of early 289 heads for sale with the 1.94/1.60...
Don, when you say a "kit" you mean just the shift kit? Or a total rebuiild kit with bands, gaskets, modulator etc?
Dave, where would you reccd I buy a "stock" kit..? Scotty P
I am having problems finding Fairbanks kits? Are they still around?
Looking foir more than just the shift kit. I have "moved the ball-bearing" and it shifts hard 1-2. Just getting soft 2-3 and is has quite a few of...
1= Heater 2= Temp sending unit 3 = Vacuum Port
Thanks, have a valve body. Just looking for reccs on bands etc..
$300 for a rebuild kit from PA. They are proud of their parts!
Found a local shop that will rebuild my C4 at a reasonable price. I would like to buy the transpak myself. What brand are people using? I have...
I run a holly blue. Mounted on the back with rubber grommets. Pretty quiet..
Sundown Sunday night!
Separate names with a comma.
