if you can weld you can make your own system. just buy a few mandrel u bends and some straight pipe and start cutting fitting and welding.
the stock throttle cable has a built in spring also.
yep. their polygraphite bushings are polyurethane with graphite infused into them. their really isnt much rubber that can be replace with poly in...
the only advice on this i have is dont use the polyurethane bushings on the strut rods. theyare too stiff and over time can cause the strut rod...
that really sucks. i feel for you guys. you son must be devastated. i cant see how the timing chain could have jumped. i would suspect something...
it depends on how it runs. if it run well, which i would expect it to, then leave it.
if its hooked up to a ported vacuum port, it wont change at idle. if its hooked up to manifold vacuum the amount it goes up depends on how much...
a member on this board works at scat. i dont remember his handle but his name is Jonathan. phone number is (310)370-5501 ext 134 im sure he will...
i would run 3.25s for average street use. you will be able to go freeway speeds and not be spinning the motor to the moon and have some good get...
with the motor off find the timing marks and mark the number you want to set it to with white out, light color touch up paint, silver or white...
loctite will work. the original bolts are crimp type design. they have a triangle like shape vs being perfectly round. so if using normal type...
that all depends on the wire sizes and loads on them. it should not be to hard to trace the power feed wire back to where its loosing power....
most likely the power feed wire to fues panel b has come apart from a connection where it sources its power. being an aftermarket modification we...
im not liking the end of the story that is basically laying blame on the owner for choosing to leave his car out instead of finding off site of...
try replacing the accelerator pump cam with another one just to see if thats what is jamming it up. i just went and looked at my carb and thats...
just a shot in the dark, is the bolt with the spring that pushes on the pump lever loose and some how deflecting and catching on something?
as the exhaust dissipates heat as it flows through the pipes it contracts and slows down. now this is a crazy high level of exhaust system...
so when the secondary accelerator pump lever is put into the mix is when it binds up?
he asked if any body had any pics of a 3" exhaust system. i didnt but had experience with putting one in. i qualified the 3" exhaust system with...
i generally recommend 3.25s for cars described like yours. the suggestions of getting a second 3rd member to swap in for long road trips is a...
Separate names with a comma.
