Building a higher RPM engine from a stock block is like pulling the pin on a hand grenade. Sooner or later it will break. We just hope it's...
the 331 kits can be had in any number of different ways. You can get just a crank, crank & rods, crank, rods, and pistons together, or you can...
it can be done but you'll have to pick up a ignition box that's programmable so that you'll have an advance or retard. Otherwise you'll be...
Looks like fun getting headers to fit. Also looks as if the rack is mounted so far forward that the tie rods are at a pretty good angle. That...
Friend of mine has one just like it. With a 501" BBF. He runs it in a heads up street radial class--and wins lots of races despite it's size and...
half and half. 1/2 Type F and 1/2 straight 30wt dino oil (the cheap stuff). Moly cam assembly lube on new flat tappet camshafts. I...
Take the whole thing off. Same for the valve guide that hangs down in the port--grind it flush with the roof of the port.
Which coolant ports are you speaking of? I have two sets of RPM heads, an early set (6025) and a newer set (5 digit part number) and both are on...
Probably is a Mustang one. I remember it having a compass in it but that was all. I didn't look that closely. It looked factory--which is why I...
Did an overhead console come factory on a '75 4 door Maverick? I found one at a salvage yard today. '75, looks like an LDO car, big bumpers,...
how bad do you want to see a running/driving 2.3 turbo Maverick? I have an engine...need a car to put it in!! Give me a 2 door Maverick and I'll...
Good job. There really is NO comparison on a street car between a automatic trans and a standard transmission of any kind. Plus having the...
They're only 225 HP. Not really a hotrod to me, as compared to a 350+ HP small block. Complicated and expensive to repair as well. Common problems...
Trick question. Keep in mind that on most M2 IFS setups that camber will change as the front end is lifted. At rest it may have zero camber. As...
What do you have already? Do you have a factory or aftermarket M2 crossmember?
the way I am reading it, you are using air pressure on the intake manifold, and hearing air rushing through the crankcase. Am I right in this...
the question still has not been answered whether it is water or oil that is leaking.
You are very lucky you still have all of your appendages! Seriously, a friend of mine called today...same problem. He has a Isuzu pickup with a...
Well it could if I had 15:1 compression. But I don't. Mine is a low compression 414" so I seriously doubt it will cause any problems. Thats the...
One of the butterfly screws came out of the throttle body (there are 3 of them). After replacing a blown fuse, I started the motor and it...
Separate names with a comma.
