I bought this manifold at a local swap meet. 8-)
You could use one of the Elanor valances or you could use the 65 Shelby type valance that has been made for a 67/68. They are both available. The...
It is not straight bolt on, but if you can handle a little fiberglass work, it can be made to fit. The body lines where it attaches at the...
The frame rails are straight and smooth, with no ripples or bulges. I have a '72 beater that has had similar damage. The frame was pulled straight...
http://www.ftw.com.au/content/view/152/50/ This web site has a good graphic of the measurements for the 65-66 and the 67-70. After looking at...
If you measure a '67-'70 Mustang front suspension, the mounting points for the upper and lower controll arms and the springs are in the same place...
The '70 Mavericks that I have looked at did not have the extra reinforcing plate. Neither does either one of my '72 Mavericks. :huh:
Okay, see above. :) The two notches at the bottom of the shock tower had to be extended to allow full suspension travel. The hole that appears...
Okay, here are a couple of pictures. 1" drop, 1/8" back. This would not work with standard upper control arms without beating on the shock tower...
Yes, Jeff is still working with them. The last I heard was the Comet project is going slow due to too many obligations, not enough time. Last...
Believe me, I know how light they get. I was clocked at 147mph in a stock body 72 Comet GT in 1985. :yikes: It must have taken me almost a week...
I plan to use this car as a teaching tool to teach my Godchildren how to race. (Autocross, 1/8 mile drags, open road racing) I do not need or want...
I know that the cam is not optimal for the aftermarket heads. Basically, the car is going to be used with an AOD and 3.25:1 rear gears. Mostly...
Okay for all you engine builders out there, I have a very basic question. I have been modeling my engine in Desktop Dyno 2000 to see what the...
Are we still talking about the wheels? :evilsmile
Well, we all know how a car is never finished. If he ever decides to use a rack and pinion steering system, everyone who looks under the hood will...
Yes, can you please give us a status update? Have you got a prototype built yet? What issues have you run into, etc. Thanks loads!
I was given a killer set of headers once. All I had to do was give up my car for a few days. :yikes: Can you get any luckier than that?...
Found this thread where it seems that shermanparts is the original source for these parts. Everyone else seems to buy from them....
Separate names with a comma.
