H.O.'s are great motors, but keep in mind they dont have the stud cast into the blocks for the manual transmissions, which is not an issue if your...
Just to note Flipping the lever doesnt work or at least it didnt for me. The angle was still far off. I could pull out of park and into gear but...
I bet your hydraulic ram is leaking too. The outter boot usually is missing on these cars and if it isnt replaced dirt gets in the ram and it...
To girdle or not is hard to answer. I have seen people swear by them, and others who havent. Personally I dont think its the horsepower that...
Disconnect the shifter and lock the transmission into park manually. Once your sure its in park you can start the car back up. Ford transmissions...
If your going through all the trouble of pulling the carpet out, I would just replace the carpet. They make repo-carpet for these cars. No matter...
Running the stock plug gap with the HEI will be fine. You may be able to run 5 or 10 thousanths more than stock but chances are your not going to...
I believe there is a place online already making and selling them. If I remember correctly they are 15$ a set.
Its not an easy task infact I did mine with the windows, quarter windows, and seats out of the car and still was not an easy task. It still took...
Basically you will need straight argon gas and the correct aluminum wire. This means the correct type and the correct thickness. You may need...
You will need the 5 lug Drums, backing plates, brake cylinders, and brakes themselves. 4 lug drums have 9" brakes where all 5 lug drum are 10"....
Pro Topline cam out when the economy was booming. They were made in new zealand but had a lot of issues with machine work. Things just didnt fit...
Look under the car and see if it has all the beam supports for the bucket seats. As mentioned someone may have changed the seats, however the...
Just buy the summit generic racing lifters. They are made by Crane Cams anyhow so your getting a good product with a low price....
Something must be off, I doubt that combo is going to make 1.6hp per cubic inch. Just to note also, those heads are really Pro-Topline heads...
I bet its one of the old holley 780cfm "3310" model carb
I had to take a second look, they look like the ones I did earlier this year. I used leather and tweed also. [IMG]
Wow, very nice, looks like the same material I used for mine. Is that tweed in the center?
Has anyone build a 331 motor with 5.315 rods? I have a set of pistons I want to put to use and just curious which crank clears, since most cranks...
I had the same exact problem! clogged fuel filter Take off the aircleaner and look down the carb, move the throttle a few times and see if fuel...
Separate names with a comma.
