Is the cam you're thinking about running a roller? You just put that it's a hyd. I'm running an 86 roller (T-Bird short blk) E7 heads, exh worked...
When my daughter saw the 75 Comet I was buying, I knew it wouldn't be mine! It was 62,000 original miles, garage kept so it's in real nice...
You need to re-jet the carb first. I just looked, it should have 66's in it. 78's are not just a little big, but way too big. You probably fouled...
Few things to look at....I didn't go look at my Holley book, but isn't that a little big on the jets for a 600? Also, you can try to wire the...
I did the 57-59 deal over 20 years ago in one of my other Mavericks. Like stated about the width, I used Centerline 8.5" rims with the 4 7/8"...
I need something for my Maverick, low HP set up. Don't want to spend $400.00 for 8" stuff....The Mustang has all the good stuff, 9", "N" case,...
These are new Repops, the inside one is what I'm not sure which side goes up.
Ok, it's only one word....Beltline.... Think of it as the seals on the inside and outside of the window that would wipe water/fog off your window...
Mine only has clips left, rubber been gone a long time. I'm not sure which is the outer, and which way is up?
Thanks!
Just wondering about the install here. I have one long piece, but the original seems to have an angle for the upper corner? Will this tuck in the...
Going to paint the inside area where the door panels are. Ok to use Krylon/Rusoleum spray can? I don't have a decent compressor so using "good"...
Bought the complete kit, just wondering if there is a basic instruction on puting in the window stuff, and around the doors.
The 70 crossmember tunnel area is a little smaller than the rest. I had a C6 in a 71, and in a 70, the 70 required notching the tunnel part out....
One Maverick I had over 20 years ago had all stock shocks, and a good (almost $200.00) set of Comp Eng traction bars. Car went 11.60 at 116mph on...
I just want plain of black, doesn't matter if it matches any original stuff.
Where at and how much?
Need to re-cover the rear seat in my 71 Grabber. The fronts are the buckets from a little later, reclining high backs. I think last time I...
You can check the driveshaft by jacking up the car and supporting it securely (gotta put the "safety" stuff in there) and put it in gear (running)...
Found some phosphoric Prep and Etch at Home Depot today, going to try using it on the rust, then Rustoleum Heavy Rust primer, the top coat with...
Separate names with a comma.
