the inside of the cap is solid steel, no holes at all, so I am assuming it isnt vented.
filler neck vent pics..... [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
heres a pic, BUT, I already have the solution. I Installed a fitting in the top of the filler neck and attached a curved length of 5/16" brake...
"on hot days"????? Whats that like? Around here we have 2 seasons, winter and july.
I'd rather have that 2-piece kit as opposed to the one piece I tried to install in my 70, would be much easier to work with having seperate halves.
yeah, oh well, I am just going to solder a small tube to the top of the filler neck and then run a hose down to the rear sill, that should do it.
Did u ever get the front valance mounted on the car? Would like to see how it looks on there.
Doesnt look like mine is, there is no hole on the backside. I would like to have it vented, so dont know if i can just drill a hole or if that...
So, we are talking about the motor mounts, one half attached to the motor, the other half attached to the frame, correct? When the two halves...
So am I right to assume there are NO new arm rests available for a 70 Maverick? Havent seen any.
My ACC carpet was junk, too short on the sides and didnt fit AT ALL. Most of that was attributable to the fact that I had to adapt the 71 and up...
nevermind, I just figured it out, thanks!!
Looking for a schematic of the switch wiring for the back up lights for a 69 1/2 Maverick. I have a 4 wire plug under the dash and am pretty sure...
I used these for my runs(you need 2 if doing both...
Some new pics of the deluxe gas cap and the Grabber grille emblem......... [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
UPDATE...... so, I just cut out a piece of rubber, about 1/16" thick, and put it on my cap. Screwed on no problem, have to see now how well it...
well, found this on mustang unlimited site......might work. http://www.mustangsunlimited.com/itemdy00.asp?T1=481+01
Anyone replace the gasket on the gas cap? I was thinking about using a flat piece of rubber, in place of the dead fiber gasket???
I'm thinking 6 1/2" but will need to check for sure.
you can get a set of spacers on ebay for about $100
Separate names with a comma.
