this is the brackets and mounts i have along with a regular old tranny mount. the motor mounts from autozone dont fit the bolt holes are to close...
the tranny hits the arms of the tranny mount and wont sit down in the center
the frame mounts from any maverick will work right? i will take some picks and post them tomorrow. i got the frame mounts from ebay and they look...
i have no clue what is wrong with my car then, i guess i will have to try and pull the tranny adn see if the engine is twisted or something.
they were made by anchor. the mustang mounts i had on there fit better than these did, i just ordered two for autozone so i will see if i have the...
i was swaping out the motor mounts because i put mustang ones in and they didnt fit so i bought maverick ones. the motor and tranny never came out...
so i probably run into the most problems out of anyone. im putting a 351w into my 71 grabber, i have the engine bolted in but the tranny is to far...
i think the AOD uses a 164 tooth flex plate at least mine did. also their are very finicky make sure you get the cable adjusted right or you will...
has anyone thought or tried to put a flathead into a maverick?? that would be pretty cool to see i think. To much power though:cry:. just wondering
i haven't drove it with the radiator i decided to put it up for the winter(lack of insurance money). i got it form a local part store cost $180...
BUMP im clueless on whats wrong? so i was reading a saw a person talking about frame mounts with a tab. i have these with a tab and they are...
yea had to switch the frame mounts cuz they were backwards :banghead:. the over hang goes towards the rear, at least in the pics thats what ive...
so im trying to fix some little stuff with my car. i got v8 frame mounts in and a new v8 tranny member. the tranny member the holes are off to...
ok so im lazy and i don't want to start a new thread. but this stupid vibration is back!!!! same thing. i had my rear seal in the tranny replaced...
everyone + myself seems to have gauge lighting problems so im trying to solve my own by altering mine to have a illumination effect on the numbers...
so im looking at rewiring my car over the winter and my freind said to buy a Ez wiring harness. http://www.ezwiring.com/wiring_harness.html. he...
i think i found it out. i had a wire pulled out of the harness.
so im changing the light bulbs in my gauge cluster. i lost one of the light bulb retainers, so i will have to go get another but my problem is...
the carb was new i got it from 69 ina 1/2 from here. im running the Mallory comp 9000 distributor, pro master coil, and the hyfire original box....
my 351w does not want to take off like it should. it will be a little bit sluggish on the take off and the secondaries will not kick in until...
Separate names with a comma.
